ReelCraft D9300 OMS Operating Instructions

Operating Instructions
Series D9000 Spring Driven Hose Reels
Stainless Steel Medium Pressure Model Numbers:
D9200 OMS D9300 OMS
D9200 OMS-S D9300 OMS-S
Dimensions

RECOMMENDED MAINTENANCE

It is recommended to disassemble, inspect and re-lube the swivel every 3 months. Disassemble, wipe off and inspect the swivel body and stem for any
evidence of galling on the metal-to-metal contact (bearing) areas. If evidence of galling is found, the swivel should be replaced. If the swivel shows no
evidence of galling, re-lube the swivel with anti-seize lubricant on the bearing areas of the swivel components and reassemble the components.
The swivel should be pressure tested to insure the o-rings are seated properly and that there is no vidence of leaking. Attach the swivel assembly to the
reel and test the hose reel assembly for leaks at the threaded connections. It is up to the customer to insure that the lubricant used is compatible with
the media they are running through the hose reel assembly.

INSTALLATION:

The swivel union is packed separately in the reel carton, use teflon tape to assure a satisfactory seal. A flexible hose
connection must be used between the hose reel inlet and the source of supply to prevent possible misalignment and
binding. Non flexible connections will void the warranty, pressure rating of inlet hose must be equal to or more than
the pressure rating of the reel. Consult factory for proper spring when installing reels above 16 ft.
Hose reel spring and bearings are factory lubricated and require no further lubrication. All mating moving parts are

LUBRICATION:

to be lubricated with Perma Bond or Locktite anti-seize compound.
REPLACING HOSE: 1. Wind spool flange clockwise-facing swivel-until spring is tight.
2. Back off three turns and latch.
3. Insert hose through roller guide.
4. Connect hose fitting to female outlet ell.

ADJUSTMENTS:

To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired tension is
obtained.

REPAIRS:

Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which may
void your warranty. Remove all spring tension before beginning disassembly process.

MODIFICATION:

Hose latching mechanism can be removed for constant tension applications.
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • reelcraft@reelcraft.com • www.reelcraft.com
A 26 1/4"
B 24 1/8"
C 4 3/4"
D 12"
E 7 3/4"
1. Models designed for fuel are coded with the prefix "F" i.e., "FD9400 OMS."
F 22 1/4"
2. Do not use reel at higher pressures or temperatures than listed on the back
G 12 1/4"
3. Remove all spring tension before beginning dissassembly process.
H 13 7/8"
4. Reel spring motor case is permanently sealed. Any attempt to remove the
J 26 3/8"

SAFETY

Check name plate on the reel before installing.
of this bulletin.
spring motor may cause serious injury.
Form# 525-787 Rev: 8/2018