ReelCraft D8400 OHP Operating Instructions

Operating Instructions
Series D8000 Spring Driven Hose Reels
High Pressure Model Numbers:
D8400 OHP D8450 OHP
D8440 OHP D8600 OHP

Dimensions

SAFETY

1. Do not use reel at higher pressures or temperatures
than listed on the back of this bulletin.
2. Remove all spring tension before beginning
dissassembly process.

INSTALLATION:

A flexible hose connection must be used between the hose reel inlet and the source of supply to prevent possible
misalignment and binding.

MOUNTING:

The hose reel is equipped with a universal mounting bracket so that it can be mounted on the floor, wall or
ceiling; whichever place is convenient. The hose guide arm can be moved to the position desired by removing
the screws fastening the guide bracket to the reel base. Shift the guide arm bracket so the hose comes off the
reel at the desired position and replace the screws.
Hose reel spring and bearings are factory lubricated and require no further lubrication.

LUBRICATION:

REPLACING HOSE: 1. Wind spool flange clockwise-facing swivel-until spring is tight.
2. Back off three turns and latch.
3. Insert hose through roller guide.
4. Connect hose fitting to swivel joint and secure hose with clamps.

ADJUSTMENTS:

To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired tension is
obtained.

REPAIRS:

Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which may
void your warranty. Remove all spring tension before beginning disassembly process.
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • reelcraft@reelcraft.com • www.reelcraft.com
D8630 OHP D8650 OHP
D8640 OHP
A 21 1/8"
B 19"
C 7 7/8"
D 3 3/4"
E 9 1/4"
Caution: When changing guide arm positions, the U-bolt must
be placed in the proper location as instructed below. The reel
can "latch out" during use if this instruction is not adhered to.
Form# 4788-84 Rev: 1/2016