Appendix; Error Messages; Troubleshooting - Nikon Coolpix S610C Connection Manual

Q7115_Wireless_EN_1st
Q7115_Wireless_EN.book Page 52 Tuesday, June 3, 2008 7:34 PM

Appendix

Error Messages

Display Problem
N
Write-protect switch is in
"lock" position.
Memory card is write
protected.
Battery exhausted during
q N
picture upload.
Battery exhausted.
Transfer terminated.
SSID was not detected.
q P
SSID not found
Wireless connection to
the SSID was terminated.
q P
Connection error.
52
A
Solution
Slide write-protect switch to
## of the
"write" position.
User's Manual
Use the AC Adapter EH-63, or
charge the battery, turn the
## of the
camera on again, and apply
User's Manual
the last mode used for picture
upload.
Signal strength may be poor.
Try the following and press
k button.
the
- Be sure that your hand is
not obstructing the
camera's antenna.
- Change the camera's
direction.
–
- Move the camera closer to
the access point.
- Remove any obstacles
between the camera's
antenna and access point.
When Retry is displayed,
select Retry and press the
k button.
Signal strength may be poor.
Try the following and press the
k button.
- Be sure that your hand is not
obstructing the camera's
antenna.
- Change the camera's –
direction.
- Move the camera closer to
the access point.
- Remove any obstacles
between the camera's
antenna and access point.
Q7115_Wireless_EN.book Page 53 Tuesday, June 3, 2008 7:34 PM
Display Problem
Connection to the server
failed, or error occurred
during picture upload.
q P
Connection error.
q P
Camera is not certified to
User information connect to the wireless
incorrect. network.
q P
my Picturetown server is
Server is full. full.
Cannot use
q P
my Picturetown network
Service not available.
service.
An error occurred with
q P
Picture Mail recipient
Address incorrect.
e-mail address.
Login error occurred.
q P
Login failed.

Troubleshooting

Problem
The camera is not detected by the Confirm your camera's connection to the
my Picturetown Utility. computer.
SSID is not displayed. Configure a network profile.
SSID is hidden.
Signal strength may be poor.
- Be sure that your hand is not obstructing
the camera's antenna.
- Change the camera's direction.
- Move the camera closer to the access
point.
- Remove any obstacles between the
camera's antenna and access point.
Appendix
A
Solution
Select Resume and press
k
the button to attempt
connection to the server
again. 49
Choose Select SSID and
k
press the button to select
SSID again.
k
Press the button and select
SSID again. 49
Delete unnecessary pictures
–
from the server.
k
Press the button and select
SSID again. 49
Be sure that you have specified
the recipient's e-mail address 34
correctly.
Select Re-enter and press
28
k
the button to configure
Email ID and password
again.
49
Select Select SSID and
k
press the button to select
SSID again.
A
Cause/Solution
15
17, 28
10
53