Sanyo HEC-DR7700C Instruction Manual page 14

ADJUSTING MASSAGE INTENSITY
When the massage is too strong
Use the massager after placing
a towel, etc., on the back pad.
When the massage is too weak
Flip the back pad to the rear.
Take off the head cover from
①
the back pad.
Flip the back pad to the rear.
②
Attach the head cover to the
③
back rest.
25
Towel
Head cover
Back pad
Back pad
Head cover
Hook-and-loop
fastener
Back rest
AFTER USE
CAUTION
After use, be sure to set the POWER switch to the [OFF] position, and the LOCK switch to the
[LOCK] position.
When the equipment will not be used for an extended period, be sure to disconnect the power
plug from the outlet.
When the foot rest is extended,
①
return the foot rest to the home
position by pulling the foot rest
slide lever.
Bring all parts of the massage chair
②
to their home position by pressing
the HOME POSITION button.
Be sure to check that there are no children,
pets, or any obstacles around the massager.
MAINTENANCE PROCEDURES
WARNING
Be sure to disconnect the power plug from the outlet prior to maintenance.
Do not attempt to use benzene, thinner, alcohol, alkaline detergent or bleaching agent for
NOTE
as this may result in deformation, discoloration or cracking.
Do not wash the head cover or the back pad. This may cause discoloration or deformation.
HEAD COVER, BACK PAD, SEAT COVER, ARM REST
Perform daily maintenance by wiping with a soft dry cloth. When they are badly soiled,
adopt the following maintenance procedure:
① Soak a soft cloth in diluted
neutral kitchen detergent,
and squeeze it well.
Wipe the main unit with
the damp cloth in
a tapping motion.
MAIN UNIT (Plastic parts and frame)
Soak a soft cloth in diluted neutral kitchen
detergent, and squeeze it well. Wipe the
main unit with the damp cloth, and wipe
it with a dry cloth afterwards.
2
Turn off the POWER.
When the display part
①
of the remote control
does not turn off, press
the OERATION ON/OFF
button.
LOCK switch
Close the cover of remote
control.
Put the remote control Lower
and the sensor controller
back on the stand.
Coin
② Set the POWER switch
to the [OFF] position,
and the LOCK switch
Press
to the [LOCK] position
using a coin.
POWER switch
cleaning,
② Soak a cloth in clean water, and
squeeze it well. Wipe off the remaining
detergent with the damp cloth.
③ Wipe it with a dry cloth afterwards.
＊ Do not force-dry with a drier.
＊ Do not make contact with vinyl products
for an extended period. It may cause
discoloration.
REMOTE CONTROL, SENSOR CONTROLLER
Wipe with a soft dry cloth.
＊Do not wipe with a damp cloth.
Press
26