Advertisement
Using the Center Support Plate
The center support allows for almost any mounting
configuration possible. If a network music player or other
larger equipment is being installed, the pre-stamped
square can be removed to make the full mounting depth
available. Additional sections may be trimmed out using
a pair of tin snips.
Dimensions in the illustration indicate the size of the
removable pre-stamped square.
Changing the Center Support Plate Position
1. Insert ¼" flat head screwdriver into the slot at the rear
of the hinge clip and twist. Pry forward while pulling
to remove it.
2. Rotate the hinge clip 180°.
3. Press the hinge clip back in with the screwdriver until
it clicks into place.
4. Repeat for each of the 4 clips.
Attaching the VersaBox Cover
To attach the cover, knock out any additional wire pass-
throughs needed, and then slid the cover on, seating the
hooks on the right side first, and pushing the left side in
until a "click" is heard.
www.snapav.com Support: 866.838.5052
6.48 in.
7.00 in.
B
C
Push in on
the opposite
side to close
SM-RBX-EXT-14 Installation Manual
Removable section
for adding Sonos
player
Perforations for
wire management
or attaching
equipment
A
Insert
hooks on
right side
first
Pg. 3
Advertisement
