Advertisement
Old Work Installation Instructions
1. Mark the desired height of the top of the SM-RBX-
EXT-14 on the wall between two stud centers. Use a
stud finder to locate the stud locations.
2. Press the rear of the SM-RBX-EXT-14 to the wall, using a
level to line it up correctly. Mark the outline of the back
of the box as neatly as possible, and then set the box
aside.
3. Carefully cut the opening using a drywall saw.
4. After the hole is cut, test fit the box, and clean up the
opening as needed.
5. Remove the center support plate from the VersaBox. The
hinge clips may be left in place.
6. Insert the box into the opening.
screwdriver, secure the box to the drywall using the dog
legs on each side of the enclosure as illustrated.
Note: If any of the 4 dog legs will not extend correctly due to stud clearance beside the box, a screw may be inserted
through the side of the box into the stud if one is close enough. Refer to the New Work Installation section earlier
in the manual for reference of where to insert the screw/s.
Installing Equipment into the VersaBox
The center support plate allows for a variety of equipment configuration options. To accommodate equipment of different
thicknesses, the plate hinges can be reversed. The plate is also perforated so that it can be trimmed down in size, or
used for securing modules and wiring.
Experiment with the equipment configuration to determine the best installation method. For images of different
configurations of equipment installed in the VersaBox, see the VersaBox product page and Support Tab at
www.SnapAV.com.
Using Knockouts
The knockouts on the top and bottom of the VersaBox may
be used for installing low voltage rings or for outlet boxes. If
an outlet box is installed, it must be an old work, residential
grade box with integrated work supports to allow for secure
mounting.
When knocking out the opening, leave the small screw tabs
installed if a low voltage ring is being mounted, or remove
them to install an outlet box.
Modules
The back wall of the VersaBox has holes and knockouts
stamped into it on 6" centers to allow for easy structured can
module installation. Use a ¼" drill bit to open more of the
knockout stamps as needed to mount equipment.
www.snapav.com Support: 866.838.5052
Using a #2 Phillips
Tighten
Dogleg
Screws with
#2 Phillips
Screwdriver
Low Voltage/Outlet
Box
Cable Entry
SM-RBX-EXT-14 Installation Manual
Cutout Dimensions
14" (W) x 13.25" (H)
Module
Attachment Holes
Pg. 2
Advertisement
