Sealey SPI1S Instructions Manual page 9

the nEGAtiVE (nEG, n, -) battery post as far away from the battery as
possible – then connect the NEGATIVE (BLACK) charger connector to
the free end of the cable.
6.5 Do not face the battery when making the final connection.
6.6 connect charger Ac supply cord to electrical outlet.
6.7 When disconnecting the charger, always do so in the reverse order of the
connecting procedure and break the first connection while as far away from
the battery as practical.
6.8 A marine (boat) battery must be removed and charged on shore. to
charge it onboard requires equipment specially designed for marine use.
7. GROUNDING AND AC POwER CORD CONNECTIONS
risK of ELEctric sHocK or firE.
7.1 this battery charger is for use on a nominal 230V, 50/60Hz circuit.
the plug must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances. the plug
pins must fit the receptacle (outlet). Do not use with an ungrounded
system.
DAngER
7.2
fit the outlet, have a proper outlet installed by a qualified electrician.
An improper connection can result in a risk of an electric shock or
electrocution.
7.3 usinG An EXtEnsion corD
the use of an extension cord is not recommended. if you must use an
extension cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and
shape as those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical
condition.
• Wire size must be large enough for the Ac ampere rating of charger.
recommended minimum AWG size for extension cord:
• 100 feet (30.5 meters) long or less – use an 18 gauge (1.0 mm
extension cord.
• Over 100 feet (30.5 meters) long – use a 16 gauge (1.31 mm
extension cord.
8. ASSEMBLY INSTRUCTIONS
Never alter the AC cord or plug provided – if it does not
• 9 •
)
2
)
2