WINYCAM Winner Quick Manual

Winner Quick Guide
Please read below introduction carefully before using.
1. Please check any defects on the product before installation. We are not responsible for any cost or expense
incurred, as a result of the failure to check before installation.
2. If the constant power discharge protection function is set 'ON', motion detection will work as parking
REC mode. If the car battery voltage becomes lower than setting value of cut off voltage, a recording will
stop even parking REC mode.
3. Below table is Recordable Time by "SD card Folder Capacity Adjustment"and"Video Quality"based on the
default setting.
Video
CH Camera
Normal
Quality
(50%)
Super High Front 96
1CH High Front 118
Normal Front 151
Super High Front/Rear 62
76
2CH High Front/Rear
Normal Front/Rear 96
By time: When the memory is full, the oldest file will be automatically deleted.
By mode: Total record files are stored by your setting rate on "SD card Folder Capacity Adjustment".
When memory is full on a particular recording mode, the oldest file will be automatically deleted on
particular recording mode. Stored file may also be deleted.
4. A Micro SD card is consumable goods. Aged SD card may cause REC error. Please replace the periodically.
(In general, the warranty period for a Micro SD card for car recorder is 6 months.)
5. When an accident occurred, please power off the product, remove the Micro SD card and save the accident
file on your PC. If long time passed after accident and the file will be deleted, we are not responsible for
missing the file.

Package

Rear Camera
Micro SD Card
Winner
Option
16GB 32GB
Motion Event Normal Motion
(20%) (30%) (50%) (20%)
39 58 196 78
47 71 239 96
61 91 307 123
25 37 127 51
30 45 154 61
39 58 196 78
(Unit : Minute)
Power Cable for Cigar Lighter
rear camera
SD Card Adaptor USB Card Reader
Fuse Cable Video Splitter Cable
GPS Module

Installation

Front Camera Installation

1. Insert Micro SD card
to Winner SD card
slot. (Check the
SD card direction)
4.
Event
(30%)
When use the Fuse cable, and insert it to exact Fuse terminal.
117 (Some Fuse is different depend of the type of car.)
143

Rear Camera Installation

184
1.
76
92
117
4.
During recording, the product may be affected by wireless devices such as radio frequency,
DMB signal, remote start device, remote controller etc. Install as far away from the antenna
and antenna cable as possible; and when cabling or tidying up cables, please avoiding the cables to be duplicated.

External GPS Module Installation

GPS module may be affected by main body or by other electronic devices if it is too close each other.
Bracket Keep a distance as much as possible.
The receiving signal may become poor depending on the climate, satellite status and geography in the neighborhood.
The receiving signal may become poor if the windshield is heavy sun-coated or fixed with metallic materials.

TV-OUT Cable Installation

When connecting to your Car Navigation, you need an applied Car Navigation video cable. With a specific Car
Navigation, installation may be restricted, and/or extra service charge may be incurred.
(Y-Type)
2. Remove a protect
sticker on Bracket.
Attach the Winner 5. Connect a Cigar
in place on the top Lighter to a Cigar
of front windshield Socket
or middle o left and
right of the mirror.
2.
Please power off a car and Remove a protect
Winner before installation. sticker and attach
a camera in place.
N(Normal),
M(Reverse of Left, Right)
The default is N(Normal).
Please power off Winner
When flip on switch.
5. Power on Winner
Connect the
and check to
( ㅡ ) shape's rear
playback a REC
camera cable to a rear
video correctly.
camera connection slot
and the ( ㄱ ) shape's
one to a main body.
Connect an external
GPS module to a GPS
terminal on the main body.
Connect a video Splitter
cable(Y-Type) to a TV-Out
terminal on a main body.
Rear camera connection cable
3. Connect Cigar
lighter cable to
Power connection
of product.
6. Arrange a power
cable.
3.
Adjust a camera
angle and fix it.
(To adjust the angle,
the horizon is seen
above the right
center of the screen.)
6. Arrange a power cable
with cable clip.
(When put cable on
the wall, please note
a PLAY cable is not
damaged.)
Fix an external GPS module
at a well visible place, and tidy
up a cable.
Connect TV-Out terminal
TV-Out signal line
Video Splitter cable(Y-Type)