Audio Settings - Pioneer DEH-S3190BT Owner's Manual

Menu Item
REGIONAL
[ON], [OFF]
LOCAL
FM: [OFF], [LV1], [LV2], [LV3], [LV4]
AM/SW: [OFF], [LV1], [LV2]
TA
[ON], [OFF]
AF
[ON], [OFF]
NEWS
[ON], [OFF]
ALARM
[ON], [OFF]
SEEK
[MAN], [PCH]
SEL DEVICE
PLAY
STOP
12
En
Description
Limit the reception to the specific regional
programs when AF (alternative frequencies
search) is selected. (Available only when FM
band is selected.)
Restrict the tuning station according to the
signal strength.
Receive current traffic information if available.
(Available only when FM band is selected.)
Allow the unit to retune to a different frequency
providing the same station. (Available only when
FM band is selected.)
Interrupt the currently selected source with
news programs. (Available only when FM band is
selected.)
Interrupt the currently selected source with
emergency announcements. Select [OFF] to
disable this function.
Assign or buttons to seek the stations
one by one (manual tuning) or select a station
from the preset channels.
Connect a Bluetooth device in the list.
Start playback.
Stop playback.

AUDIO settings

NOTE
[CHK APP SETTG.] may be displayed when the setting is performed from Pioneer Smart Sync.
Menu Item
EQ SETTING
[SUPER BASS], [POWERFUL],
[DYNAMIC], [TODOROKI],
[VOCAL], [VIVID], [SET BY APP]*,
[CUSTOM1], [CUSTOM2], [FLAT]
* [SET BY APP] is displayed when
the preset equalizer curve that is
not available in the unit has been
set from Pioneer Smart Sync.
Select an equalizer band and
level for further customizing.
Equalizer band: [50HZ] to
[12.5kHZ]
Equalizer level: [–6] to [+6]
FADER*1
BALANCE
SUBWOOFER
[ON], [OFF]
SUBWOOFER*2
[NOR], [REV]
SPEAKER LEVEL
Types of speaker: [FRONT L],
[FRONT R], [REAR L], [REAR R],
[SUBWOOFER]
Output level: [–24] to [10]
CROSSOVER
Description
Select or customize the equalizer curve.
• When you select a setting other than
[CUSTOM1], [CUSTOM2] and [SET BY APP], you
can also customize the equalizer curve by
pressing and holding the M.C. dial, then store
the customized equalizer curve in [CUSTOM1].
Adjust the front and rear speaker balance.
Adjust the left and right speaker balance.
Set to [ON] when using a subwoofer speaker.
Select the subwoofer phase.
Select a speaker unit (filter) and adjust the
output level.
• Each value you have adjusted changes when
you change the [POSITION] setting (page 13).
Select a speaker unit (filter) to adjust the HPF or
LPF cut-off frequency and the slope for each
speaker unit.
For details on the [CROSSOVER] setting, see
page 11.