Tv Operation - Sansui HDLCD1900 Owner's Manual

NOTE:
• If a channel with no broadcast is
selected, the sound will automatically
be muted.
• It may take a few seconds for a digital
channel picture to appear on screen
after being selected.
1
To turn on the TV, press POWER.
2
Adjust the volume level by
pressing VOL + or – . The volume
level will be indicated on the
screen by white bars. As the
volume level increases, so do the
number of bars. If the volume
decreases, the number of white
bars also decreases.
3
Set the Tuning Band menu
option to the appropriate
position (see page 18).
4
Press the Direct Channel
Selection (0-9, –) buttons to select
the channel.
TO SELECT ANALOG CHANNELS
1-9: Press 0 twice, then 1-9 as
needed. Example, to select channel 2, press 0, 0, 2.
10-99: Press 0, then the remaining 2 digits. Example, to
select channel 12, press 0, 1, 2.
100-125: Press the 3 digits in order. Example, to select
channel 120, press 1, 2, 0.
TO SELECT DIGITAL CHANNELS
Press the first 3 digits, then press the – button, followed by the
remaining 3 digits.
Example, to select channel 015-001, press 0, 1, 5, –, 0, 0, 1.
• If a channel is selected with only audio content, "AUDIO
ONLY" will be displayed on the screen.
• If a channel is selected with a weak digital signal, "DIGITAL
CHANNEL SIGNAL STRENGTH IS LOW" will be displayed
on the screen.
If the digital channel has the same analog channel, you way
be able to watch the same channel with analog.
• If a channel is selected to which you have not subscribed,
"DIGITAL CHANNEL IS ENCRIPTED" will be displayed on
the screen.
VHF/UHF/CABLE CHANNELS
Air
VHF
2-13
UHF
14-69

TV operation

Volume
Air - VHF/UHF channels
Cable - CABLE TV channels
Cable
VHF
2-13
STD/HRC/IRC
14-36 (A) (W)
37-59 (AA) (WW)
60-85 (AAA) (ZZZ)
86-94 (86) (94)
95-99 (A-5) (A-1)
100-125 (100) (125)
01 (5A)
14
C h 9
21