Related Manuals for Snow Performance 20130
Summary of Contents for Snow Performance 20130
- Page 1 INSTALLATION INSTRUCTIONS FOR PART #20130 MUSTANG STAGE 3 BOOST COOLER® WATER/METHANOL INJECTION SYSTEM © 2010, Snow Performance, Incorporated...
- Page 2 Contact Us ..24 Have a question? FAQ: www.snowperformance.net/faqs.php CAUTION You must completely read though these instructions before installing and operating this product. Failure to due so can result in damage to this product and the vehicle. © 2010, Snow Performance, Inc...
- Page 3 - Electric drill w/ drill bits Hose Adaptor or Bung - Adjustable wrench SafeInjection® - Utility knife Nitrobooster® - Screw driver – Phillips Dual Nozzle - 5/16” open end wrench (for nozzle) Carb Plate -1/8” NPT Tap © 2010, Snow Performance, Inc...
- Page 4 No part of or this entire document may be reproduced in any form Clear Boost Tube without prior written permission of Snow Performance, Inc under the copyright except for private use. The names, addresses and telephone numbers mentioned are current as White - To of January 1, 2009.
- Page 5 Note that in some cases it will be easier to mount the bulkhead fitting in the side of the tank so that the hose exits in the direction of the pump. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 6 Warranty Policy to use a check valve in-line between the reservoir and pump. Do not Snow Performance, Inc. warrants that the Product shall conform to and perform in operate your rear mount equipped vehicle without a check valve accordance with published technical specifications and shall be free of defects in materials installed.
- Page 7 A naturally aspirated engine making 300-400 HP will use a 100 ML/MN damage to related systems. This is a high performance product – use at your own risk. Snow Performance Inc., Its agents, employees or owners shall not be under any liability nozzle or a 175 ML/MN nozzle.
- Page 8 Connect the second BLACK wire to a secure chassis ground location. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 9 Connect one black wire from level switch to ground. • Connect other black wire from level switch to white wire from • LED. Connect red wire from LED to +12 volt key on power source. • © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 10 Step 5 Nozzle Connection For best performance, cooling and system life it is recommend that Snow Performance Boost Juice™, part #40008, be the exclusive Measure the distance from the pump outlet to the nozzle holder(s). Cut fluid used in the system.
- Page 11 All functions of the controller are accessed using the two push buttons to for system lubrication. the left and right of the LCD screen. Pressing button 1 will scroll between © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 12 Set the controller to inject at 1 psig of boost, and to start injection at • 1% PW. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 13 In most applications, this should be set at a boost Note: for best results, prime pump before use achieved at WOT in hard driving. To clear air from the pump and insure that the system is primed: © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 14 3 psig even in moderate throttle situations, and can hit 15 psig application is different and will work best with different settings. almost instantly. Naturally Aspirated EFI Mustang: Injection Mode: ‘Both’ © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
Need help?
Do you have a question about the 20130 and is the answer not in the manual?
Questions and answers