Subscribe to Our Youtube Channel
Related Manuals for Snow Performance 20020
Summary of Contents for Snow Performance 20020
- Page 1 INSTALLATION INSTRUCTIONS FOR PART #20020 MC/MC2/DOM WATER / METHANOL INJECTION SYSTEMS NATURALLY ASPIRATED /CARBURETED © 2010, Snow Performance, Incorporated...
- Page 2 Contact Us Have a question? FAQ: www.snowperformance.net/faqs.php CAUTION You must completely read though these instructions before installing and operating this product. Failure to do so can result in damage to this product and the vehicle. © 2010, Snow Performance, Inc...
- Page 3 Harness 375ML/MN (5) 10 Tie Wraps 625ML/MN (6) Level Switch Upgrade Upgrades Required Tools Bulkhead Adjustable Wrench 2.5 Gallon Reservoir Utility Knife SafeInjection® Screwdriver – Phillips Nitrobooster® 5/16” Open End Wrench Dual Nozzle Boost Juice © 2010, Snow Performance, Inc...
- Page 4 The contents of this document are subject to change without prior notice. No part of or this entire document may be reproduced in any form without prior written permission of Snow Performance, Inc under the copyright except for private use.
- Page 5 • While pulling firmly on the red tubing, tighten the outer nut using a 17mm socket (only needs to be hand tight). A ratchet is not needed. • Once sealant has set, fill reservoir with water and check for leaks. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 6 Warranty Policy To avoid gravity feeding of fluid with rear mount reservoirs, it is essential Snow Performance, Inc. warrants that the Product shall conform to and perform in to use a check valve in-line between the reservoir and pump. Do not...
- Page 7 Keep the pump Snow Performance Inc., Its agents, employees or owners shall not be under any liability whether in contract or otherwise whether or not resulting from our negligence or contents of within 2 feet of the reservoir.
- Page 8 1/5 of max reservoir height. the nozzle holder. Torque 1/2 turn past finger tight. Do not use Teflon sealants on Snow Performance fittings. Carefully drill side of reservoir using 13/16” bit. A step bit is •...
- Page 9 For best performance, cooling and system life it is recommend that Twin Carb: Snow Performance Boost Juice™, part #40008, be the exclusive Connect hose from the “1” port of the solenoid to the ‘T’ fitting. Connect fluid used in the system.
- Page 10 Over time the internal gripping teeth may lose their hold of the tubing which may create a leak. If this occurs simply remove the tubing and make a fresh cut using a razor blade. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 11 PURPLE wire is only used during initial setup, and then can be tied • out of the way. Always have a good electrical ground connection. Poor ground will result in erratic operation. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
- Page 12 Next, adjust “Full” to the engines minimum vacuum, usually 0. • It may be possible to set the full point at a point before 0 for more • aggressive injection. © 2010, Snow Performance, Inc © 2010, Snow Performance, Inc...
Need help?
Do you have a question about the 20020 and is the answer not in the manual?
Questions and answers