Table of Contents
Advertisement
with. The installation of the equipment MUST be
in accordance with the relevant requirements of
the Gas Safety Regulations, Building Regulations,
I.E.E. Regulations and the bylaws of the local
water undertaking.
In addition, the installation should follow the
relevant guidance offered in the following
documents. It is not practical to list all relevant
information due to continuous changes but
emphasis is placed on the following documents,
as failure to comply with the guidance given will
almost certainly result in an unsatisfactory
installation:
•
British Standards (BS)
•
Institute of Gas Engineers and Managers
(IGEM) Publications
•
CIBSE Guides
•
Clean Air Act
•
H.S.E Guidance
n
Note
Manufacturer's notes must not be taken in any
way as overriding statutory obligations.
Contact information
If you have any comments or questions, please
contact:
A.O. Smith Water Products Company
Adress:
PO Box 70
5500 AB Veldhoven
The Netherlands
Telephone:
0870 - AOSMITH (free)
0870 - 267 64 84
General:
+31 40 294 25 00
Fax:
+31 40 294 25 39
E-mail:
info@aosmith.nl
Website:
www.aosmith.co.uk
In the event of problems with your gas,
electricity or water supply connections, please
contact your supplier.
About this manual
Scope
This manual gives information about safe and
correct use of the water heater and how
installation, maintenance and service activities
have to be done correctly. You must obey the
instructions in this manual.
4
c
Caution
Read this manual carefully before you start the
water heater. It can cause personal injury and
damage to the water heater when you do not
read the manual and/or do not obey the
instructions.
The purpose of this manual is to:
•
describe the working principles and layout of
the water heater
•
explain the safety devices
•
highlight possible hazards
•
describe the use of the water heater
•
describe the installation, service and
maintenance of the water heater
This manual has two parts:
•
An User part that describes the correct usage
of the water heater.
•
An Installation, Maintenance and Service
part, that describes the correct installation
and maintenance procedures.
Target group
The information in this manual applies to three
target groups:
•
users
•
installation engineers
•
service and maintenance engineers
The User part is intended for the (end) users.
The Installation, Maintenance and Service part is
intended for the installation engineers and the
service and maintenance engineers.
Notation conventions
This manual uses the following text conventions:
•
Numbers between parentheses e.g. (1), refer
to elements in a figure that are described by
the text.
•
Knobs or symbols on the knobs are always
shown between brackets, for example:
[
], [ ], [ ].
•
Cross-references to sections, tables, figures
etc. are underlined and written as (see "...").
In the digital version, the cross-references
function as hyperlinks that can be used to
navigate through the manual by clicking on
them. Example: Safety (see 2).
This manual contains the following text styles/
symbols for situations that may endanger users/
Advertisement
Table of Contents
