Related Manuals for A.O. Smith BTL 100
Summary of Contents for A.O. Smith BTL 100
- Page 1 BTL 85 BTL 100 United Kingdom & Ireland HOT WATER STORAGE HEATERS Installation, User and Service Manual Innovation has a name.
-
Page 3: Preface
A.O. Smith A.O. Smith accepts no liability for claims from Water Products Company. third parties when: A.O. -
Page 4: Contact Information
If you have any comments or questions, please contact: • users • installation engineers A.O. Smith Water Products Company • service and maintenance engineers Adress: PO Box 70 The User part is intended for the (end) users. 5500 AB Veldhoven... -
Page 5: Table Of Contents
3.1.1 Operation control knob.......7 engineers, cause damage to equipment or need special attention: 3.1.2 Temperature control knob....8 Status of the water heater....8 Note 3.2.1 Operating modes.......8 A note gives more information on a topic. Use..........8 Turn on the water heater....8 Caution 4.1.1 Temperature setting...... -
Page 6: User Part
To operate the water heater, the control knobs on A.O. Smith cannot be held responsible for the gas control valve (5) are used. damages or injuries which can be lead back to: •... -
Page 7: Operation
Warning 3 Operation If you smell gas: Shut off the mains gas supply valve! 3.1 Control components Avoid causing sparks! Do not use any electrical equipment or switch, i.e. no For the use of the BTL water heater, the gas telephones, plugs or bells! control valve has two control knobs: No naked flames! No smoking! -
Page 8: Temperature Control Knob
To prevent that the water in the system freezes, Symbol Explanation the frost protection is activated when the water Water heater is activated, the heater is in OFF mode. The frost protection pilot flame burns (frost starts when the temperature of the water drops protection). -
Page 9: Temperature Setting
4.1.1 Temperature setting through an heat exchanger. The water heater has an open flue gas discharge connection. Use the temperature control knob to set the 5.2 Working principle temperature: • Position 1 = approximately 40°C Cold water enters the tank through the water •... -
Page 10: Safety
Note 6 Safety Any leakage from the tank and/or connections can cause damage to the immediate environment or floors below the level of the 6.1 Safety instructions boiler room. Install the water heater above a waste water drain or in a suitable metal leak For safety instructions on the use of the water tray. -
Page 11: Safety Devices
97°C. the pressure exceeds 7 bar. 1- All appliances have a T&P valve connection. A.O. Smith recommends to use a T&P valve. 6.4 Environmental aspects 6.4.2 Disposal 6.4.1 Recycling Old end-of-life appliances contain materials that The packaging material is environmentally need to be recycled. -
Page 12: Water Heater
Fig. Components water heater 7 Water heater 7.1 Structure of the water heater The water heater has the following main components: Tank The water is stored and heated up in the tank. Burners The burners (with a pilot flame) ignite the air and gas mixture to heat up the water. -
Page 13: Installation
8.1 Packaging cannot be guaranteed, refer to Warranty (see A.O. Smith recommends to unpack the water heater at or near its intended location. Remove the packaging material carefully to prevent 8.2.4 Working clearances damage to the water heater. -
Page 14: Placement Of The Water Heater
8.2.5 Placement of the water Use this installation diagram when you: heater install the water connections Before you install the water connections and gas (see 8.4) connections, place the water heater on the install the gas connection (see correct position and make sure that the water 8.5) heater is level. -
Page 15: Drain Valve
4. Install the gas supply pipe to the gas control valve. Note 5. Make sure that there are no gas leaks. Use the drain valve connection (9) as a connection of the circulation pipe on the water 8.6 Flue gas discharge heater. -
Page 16: Discharge Pipe
2. Use the screws to install the bracket on the 3. Make sure that the drain valve (9) is closed. water heater. 4. Open all hot water draw-off points (14) to 3. If necessary, use the screws to install the bleed the entire installation of air. -
Page 17: Turn On The Water Heater
Refer to the procedure in the user part to Turn temperature. off the water heater (see 4.2). To determine the correct interval, A.O. Smith 8.8.2 Draining recommends to do a system check on both the water and the gas side, three months after Refer to the installation diagram (see 8.3) when... -
Page 18: Performance Check
3. Use a wrench to loosen the anode. 10.1 Performance check 4. Take the anode out of the water heater. 5. Inspect the volume of the anode. When the anode is consumed for 60 % or more, replace Check if the performance of all components is the anode. -
Page 19: Descale The Tank
If necessary use a descaling agent to remove the scale and contamination from Fig. Disconnect the burners the tank. Contact A.O. Smith for advice on what descaling agent to use. 8. Replace the gasket. 9. Close the cleaning opening. -
Page 20: Clean The Combustion Chamber
9. Take the burners out of the water heater. 2. Make sure the gas supply pressure is correct. If the gas supply pressure is not correct, Fig. Remove the burners contact your mains gas supply company. Do not use the water heater. 3. -
Page 21: Condensation
2. Push on the reset button on the T.R.S. 11.1.3 Condensation thermostat to reset the T.R.S. 3. Turn on the water heater (see 4.1), because Condensation of flue gases can occur on the cold the main burner and the pilot burner are OFF. surfaces of the combustion chamber and the flue gas discharge pipe when the water heater is Note... -
Page 22: General Errors
11.2 General errors Indication Cause Measure Gas smell There is a gas leak. Close the main gas valve at once. Do not operate any switches. No naked flames. Ventilate the boiler room. Immediately contact your installation engineer or your local gas company. Insufficient or no hot Contaminated pilot burner. -
Page 23: Appendices
Trace the leakage. another nearby water heater or pipe segment. 12 Appendices 12.1 Technical details Description Unit BTL 85 BTL 100 Capacity Empty Weight Maximum floor load Maximum operating pressure kPa (bar) 550 (5.5) 550 (5.5) Control thermostat - adjustment °C... -
Page 24: Dimensions
12.2 Dimensions Size Description Unit BTL 85 BTL 100 Dimensions water heater Height 1595 1780 Width Depth Flue gas outlet Dimensions connections Cold water supply connection 1" 1 1/4" (female) Hot water outlet connection 1" 1 1/4" (female) Gas control valve connection Rp 1/2"... -
Page 25: Ecodesign Details
12.3 EcoDesign details Description Unit BTL 85 BTL 100 Declared load profile Load profile Energy efficiency class (energy label) Energy efficiency Daily electricity usage Daily fuel consumption kWh GCV 37.940 42.545 Mixed water 40°C (V40) 1246 Additional load profile Load profile... - Page 26 Description Unit BTL 85 BTL 100 Daily fuel consumption kWh GCV 44.315 72.544 Mixed water 40°C (V40) Installation, Maintenance and Service part...
-
Page 27: Gas Details
12.4 Gas details Description Unit BTL 85 BTL 100 Gas category 2H (G20) Diameter main orifice 2.75 3.00 Diameter orifice pilot burner 2 x 0.27 2 x 0.27 Nominal load 22.1 21.0 (Gross) Nominal output 16.8 16.6 Supply pressure mbar 20.0... - Page 28 Description Unit BTL 85 BTL 100 Diameter orifice pilot burner 2 x 0.16 2 x 0.16 Nominal load 17.9 17.8 (Gross) Nominal output 13.9 14.4 Supply pressure mbar 37.0 37.0 Burner pressure mbar Gas consumption kg/h -emission mg/kWh Mass flow rate flue gases...
-
Page 29: Declaration Of Conformity
12.5 Declaration of conformity 0313126_BTL_UKUK_V1.1, 30-11-2018... -
Page 30: Warranty
The water heater is connected to a protected of the glass lined steel tank) of a water heater cold water supply arrangement, which is supplied by A.O. Smith proves within one year of approved by the relevant authority; with the original installation date to be defective or sufficient capacity for this purpose;... - Page 31 Articles. Under the terms of the supplied warranty, A.O. Smith is not liable for damage to persons or property caused by (assemblies or parts, or the glass-lined steel tank of) a (replacement) water heater that it has supplied.
- Page 32 Nederland United Kingdom A.O. Smith Water Products Company B.V. A.O. Smith Water Heaters Postbus 70 Unit B8 Armstrong Mall, Southwood Business Park, 5500 AB VELDHOVEN Farnborough, Hampshire, GU14 0NR 0800 - AOSMITH (2676484) 0870 - AOSMITH (267 6484) info@aosmith.nl info@aosmith.nl www.aosmith.nl...