Unpacking And Assembly - Simplicity 1695764 Operator's Manual

UNPACKING & ASSEMBLY
UNPACK MINI CULTIvATOR
1. Carefully lift the mini cultivator out of the box, remove any
packing material and cut any ties holding the handlebar
pieces to the mini cultivator assembly.
ASSEMBLY
1. Stand the mini cultivator assembly upright with tines
and wheels on a level surface. Wheels should be set in
the lowest position. DO NOT place the mini cultivator
on a high surface where it can fall and cause property
damage or personal injury.
2. Using two tee handle nuts, two bolts, and two curved
washers, assemble the middle handlebar to the lower
handlebar that is already attached to the mini cultivator
assembly. SEE FIGURE 1. The middle handlebar can
be installed in two positions one high and one low. DO
NOT overtighten the tee handle nuts.
3. Attach the upper right and left handlebars to the middle
handlebar using the two remaining tee handle nuts,
bolts, and curved washers. SEE FIGURE 1. DO NOT
overtighten the tee handle nuts.
4. The drag stake is shipped with point facing upwards.
Before using, remove detent pin and turn the drag
stake around so the point is directed in the downward
position facing towards the tines. Re-insert detent pin.
SEE FIGURE 2A.
For the Electric Start Mini Cultivator Model, remove the
battery box cover and plug the white plastic connector from
the battery into the mating white plastic connector in the
battery box. SEE FIGURE 2B. Make sure the ignition key
is removed from the ignition before connecting the wiring
for the battery.
FIGURE 2B
OPERATOR INSTRUCTIONS
Mini Cultivator
FIGURE 1
FIGURE 2A
Page