Hausmann 4300 Installation & Operation Instructions

Model # Length
4300 60"
4320 66"
Figure 1: Model 4320
Tool Required:
Philips Screwdriver
Slotted Screwdriver
A) INSTALLATION INSTRUCTIONS
Tabletop Assembly:
1. Remove all items from packaging and assure
all parts and components are accounted for.
2. Carefully crank handle 'G' up a few inches
making sure to not kink the tubing of the crank
assembly.
3. Fasten the brake clamp 'F' (Model 4320 only).
4. Place the tabletop 'A' on top of mounting plate
'B'.
5. Attach the top 'A' to the mounting plate 'B'
with four Machine Bolts 'L' and washers.
6. Carefully lift up Crank handle assembly 'G'
making sure not to kink the tubing and attach
the it to the bottom of top 'A' with the 3 screws 'N' into the
predrilled holes under the tabletop.
7. Secure the tubing to the under the tabletop with the loop & screw.
NOTE: Allow enough slack to hang below where the tubing is attached.
Rev. 110514 aj
130 Union St • Northvale NJ 07647 USA • Tel: (201) 767-0255 • Fax: (201) 767-1369 •
Installation/Operation Instructions
Model 4300 and 4320 – Crank Hydraulic Work Table
Width Height Weight
Capaity
36" 29" – 41" 250 lbs
48" 29" – 41" 250 lbs
PART QTY
Tabletop 1 ½" x 36" x 60" (Model 4300 only)
A 1
Tabletop 1 ½" x 48" x 65" (Model 4320 only)
Lift chassis including the bottom subplate 'K'
B 1
C 1 Base plate
Hydraulic pump with hose (connected to
D 1
crank pump assembly)
Brake clamp (Model 4320 only)
F 4
Crank Handle
G 1
H 1 Hydraulic Tubing
Mounting Plate
I 1
Top Subplate
J 1
K 1 Bottom Subplate
Phillips 1/4" - 20 X 1 3/4" Machine screw
L 4
and washers
Tubing for Crank Handle Assembly
M 1
Phillips 1/4"-20 X 2" Machine Screws for
N 4
Crank Handle Assemble
L
D
Figure 2: TableTop Assembly
Page 1 of 2
www.hausmann.com
PARTS LIST
DESCRIPTION
J
K
F
G
C
©2014 HAUSMANN INDUSTRIES, INC.
H