Selecting A Location; Adjusting The Leveling Feet; Removing The Shipping Bolts; Connecting The Water Supply Hose(Option) - Samsung J1055AC Owner's Instructions Manual

Installing the Washing Machine

Selecting a location

Before you install the washing machine, select a location with the following characteristics:
 A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet," below)
 Away from direct sunlight.
 Adequate ventilation
 Room temperature that will not fall below 0 ˚C
 Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.

Adjusting the leveling feet

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under
the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the desired height.
2. Tighten the locking nut by turning it with the supplied wrench.
Place the washer on a sturdy, flat surface.

If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Only a l
degrees angle is allowed.)

Removing the shipping bolts

Before using the washing machine, you must remove the five shipping bolts from the back of
the unit. To remove the bolts:
1. Loosen all bolts with the supplied wrench before removing them.
2. Take each bolt head and pull it through the wide part of the hole. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.

Connecting the water supply hose(Option)

1. Remove the adaptor from the
water supply hose.
2. First, using a "+" type screw driver, loosen the four
screws on the adaptor. Next, take the adaptor and
turn part(b) following the arrow until there is a 5mm
gap.
3. Connect adaptor to the water tap by tightening the
screws firmly.
Then, turn part (b) following the arrow and put(a) and
(b) together.
NOTICE
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square
or too big, remove the spacing ring before inserting the faucet into the adaptor.
Cotton
Remaining Time
Synthetic
Pre-wash
Delicate
12:00 o C
Wash
rpm Wool
Rinse Power
Min
START
Speedy
Spin
PAUSE
Check Delay Start
Eco
Fuzzy control
Door open
Temp Spin Delay Start Function
2
1
3
4. Connect the water supply hose to the adaptor. Pull
down part (c) of the water supply hose. When you
release part (c) the hose automatically connects to
c
the adaptor making a ' c lick' sound.
5. Connect the other end of the water supply hose to
the inlet water valve at the top of the washer. Screw
the hose clockwise all the way in.

If the water tap has a screw type faucet, connect the
water supply hose to the tap as shown.
a
b
SAMSUNG
Washing Machine Owner's Instructions
3