Using The Master Edit Control System; Setting The Edit-Out Point Using Counter - JVC GR-45 Instructions Manual

Using the Master Edit Control System
This function is available when usinq designated JVC video decks equipped with a remote pause terminal. The
Master Edit Control system allows control of the connected deck using the VideoMovie's controls, preroll editing
or edits free of transition-point gaps and distortion.
Connection
1. Connect the AV OUT connector of the GR-45E to 2.
the AUDIO and VIDEO IN connectors and remote
pause terminal of the video recorder. 3.
Operation
Dubbing can be initiated from Stop mode or Still mode.
Connect a television to the video recorder to
monitor the picture while dubbing.
Set the DUBBING ON/OFF switch to ON.
• For dubbing a tape
1. Switch on the VideoMovie's power.
2. Switch on the deck's power.
3. Put the deck in the Record-Pause mode.
4. Press the QUICK REVIEW/EDIT button to start
editing. The tape is loaded, then dubbing starts.
5. Tape stop when the PAUSE/STILL or STOP but¬
ton of the GR-45E is pressed or counter reaches
"OM".
6. Deck stops recording and enters the Record-Pause
mode
• For editing
1. Switch on the VideoMovie's power.
2. Turn on the deck's power.
3. Put the deck in the Record-Pause mode.
4. Locate the edit-in point via play, fast-forward,
rewind, or Shuttle Search, and press the PAUSE/
STILL button.
5. Press the QUICK REVIEW/EDIT button to start
editing.
6. Tape stops when the PAUSE/STILL or STOP
button of the GR-45E is pressed or counter
reaches "OM".
7. Deck stops recording and enters the Record-Pause
mode.
Note:
When the EDIT button is pressed from the Still mode,
the tape is rewound for 5 seconds of program time.
The Play indicator appears on the LCD display to
indicate rewinding is taking place. After prerolling,
first the prerolled section is played back for stabiliz
ing tape run. During playback of the GR-45E, it
gives a start signal to the deck standing by in the
Record-Pause mode to start playback and then tc
enter the Recording mode at edit-in point, while the
GR-45E continues playback. The Master Edit Contro
indicator appears on the LCD display during dubbing
Setting the edit-out point using counter memory
In the above procedures, counter memory can be used to set the edit-out point before editing takes place, s<
that the VideoMovie automatically stops playback at the designated point. If the edit-out point is to be set if
this way, do so following step 3 of the dubbing operation.
1. Locate the desired edit-out point on the Video- Note:
Movie's tape. When the tape reaches the preset edit-out poin
2. Press the VideoMovie's PAUSE/STILL button. during the dubbing operation, it may stop slight!'
3. Reset the VideoMovie's counter to "0". before or after the designated point on the tape.
4. Press the VideoMovie's counter MEMORY button.
5. The VideoMovie enters the Pause mode, and the
deck enters the Record-Pause mode.