Using The Gr-45E As A Video Camera - JVC GR-45 Instructions Manual

USING THE GR-45E AS A VIDEO CAMERA
For continuous documentation of longer events, the GR-45E can be used as an indepen
combination with either a deck-type or portable video recorder.
Using a recorder not equipped with a remote pause terminal
•Connect the AV OUT connector of the GR-45E to the AUDIO and VIDEO IN connectors of the video
using the optional dubbing cable.
Operation
1. Press the MONITOR button.
The camera output signal is now
available via the dubbing cable.
2. Put the connected recorder in
the Record mode. Recording
will start. Tape start/stop should
be controlled with the recorder's
buttons.
• In this configuration, it is possible to obtain a continuous recording and an edited-out recor ing
event simultaneously, because the GR-45E's start/stop button only controls the tape inside itsel w i e
tape loaded in the connected recorder continues running. To record on the GR-45E s tape, o ow e
recording procedure as mentioned before: press REC standby and then the start/stop button.
Using a recorder equipped with a remote pause terminal or with a 10-pin camera connector
For a recorder with a remote pause terminal
•Connect the AV OUT connector of the GR-45E to the AUDIO and VIDEO IN connectors and remote pause
terminal of the video recorder using the optional dubbing cable.
For a recorder with a 10-pin camera connector
•Connect the AV OUT connector of the GR-45E to the 10-pin camera connector of the second recorder using
the optional VC-V810U conversion cable.
Operation
1. Press the MONITOR button.
2. Press the connected recorder in
the Recording Standby (Record-
Pause) mode.
•The viewfinder's mode indica¬
tion corresponds to the state of
the connected recorder.
3. Press the start/stop button of
the GR-45E to start recording.
Note:
•To record on the GR-45E's tape as well, press the REC standby button and then the start/stop button.
Precautions
•Power is not supplied to the GR-45E from the connected VCR. Independent power supply is required for both
the GR-45E and the VCR.
• If you stop recording by pressing the GR-45E's start/stop button, the connected VCR also stops in the Pause
mode. However, the pause command signal is not delivered to the connected VCR in the following cases and,
therefore, the VCR will start automatically:
(1) when the GR-45E is switched off or its battery becomes discharged.
(2) when the VC-V81OU cable is disconnected.
Therefore, before replacing the battery or tape for the GR-45E, put the connected VCR either in the STOP or
REC LOCK mode.
22