Product Specifications - Yamaha PDS-242 Installation Instructions Manual

PDS-242_E 2003.12.11 11:23 2
Parts Configuration Chart
Pedestal base x 1
Support x 2

Product Specifications

700 (W) x 184 (H) x 300 (D) mm
External
Dimensions (27-9/16 (W) x 7-1/4 (H) x 35-7/16 (D) inches)
4.2kg
Weight
(9 lbs. 4 oz.)
Main material
Pedestal base, Support : Aluminum alloy / Baked paint finish
/Surface
treatment
Usage cautions
I Do not allow an adhesive material, such as an adhesive tape, into
contact with the surface of the pedestal, as they may cause the exterior
surface to peel.
I Wipe off dirt using a dry cloth. To remove ingrained dirt, use a cloth
saturated with a diluted neutral detergent solution and squeezed until
damp. Use of organic solvents, such as benzine, thinner, and household
wax, for cleaning could result in a degenerated or discolored material.
(When using a chemical duster, observe the relevant instructions.)
Assembly Method
Included in the parts package
Assembling the pedestal
1. Insert the support into the pedestal base and secure it in
position by tightening four M5 x 20 screws from the bottom.
M6 x 30 screws M5 x 20 screws
x 4 x 4
Cable clamp x 2 M5 x 20 screw
(4)
Dimension diagram
Prepare a phillips screwdriver before proceeding with assembly.
Pedestal base
Support (2)
124 89
1030 (40-9/16) (4-7/8) (3-1/2)
700 (27-9/16) 300 (11-13/16)
Unit: mm (inches)
Attaching the Plasma Monitor to the pedestal
2. Insert the pedestal support into the square holes on the
bottom of the plasma monitor.
Plasma monitor
Pedestal
3. Fix the pedestal to the plasma monitor using four M6 x 30
screws.
M6 x 30 screw (4) Cable clamp
4. Connect the cables to the plasma monitor, attach the
cable clamps to the pedestal where necessary, and fasten
the cables to the clamps.