Step 5 - Set Watering Start Conditions - Base Line BaseStation 1000 Quick Start Manual

BaseStation 1000 Quick Start Guide
STEP 5 – Set Watering Start Conditions
A program is not active until you select a start condition for it.
Press the Program Setup button. Highlight the Setup Prg. Start option, and then press OK. For the
initial system configuration, we recommend that you set up a Day & Time Start. After you verify
that your system is watering as expected, you can add other start conditions or switch to a
different start condition.
Verify that the correct program number displays in the upper-left corner. Press PRG to change if
necessary.
Press the  button to highlight the Day & Time Start option, and then press the + button to select
the option. Press the OK button to go to the next menu level.
Press the  button to highlight the Set Start Days option, and then press the OK button to go to
the Set Start Days screen.
Again, for the initial system configuration, we
recommend that you set up the Weekday option.
After you verify your system is watering as
expected, you can change to another start day
option.
In the Set Weekdays screen, press the  button to
set up the weekdays when you want the program to
start. By default, the boxes for the days of the week
are marked with a checkmark, which indicates that the program will start every day. If you want to
change a start day setting, press the  button to select the day, and then press the OK button to
change the setting.
Press the BACK button to return to the Day & Time Start menu.
Press the  button to highlight the Set Start Times option, and then press the OK button. The Set
Start Times screen displays.
Note: Each active program must have at least one start time. Programs that have no start times will
not run.
Press the  button to highlight the box for the start time that you want to change.
Press the + or – button to change the number in the box.
Page 5