Quick Start Your Controller; Step 1 - Install And Connect Devices; Step 2 - Search For And Assign Devices; Step 3 - Set The Date And Time On The Controller - Base Line BaseStation 1000 Quick Start Manual

BaseStation 1000 Quick Start Guide

Quick Start Your Controller

These instructions walk you through the basic steps for getting your controller configured for
watering. Refer to the User Manual for complete instructions for all of the controller's features.
STEP 1 – Install and Connect Devices
Install all of your irrigation devices and connect them to the controller according to the instructions
that came with the devices.
STEP 2 – Search For and Assign Devices
Press the Search & Assign button on the controller
and go through each option to find the devices that
you connected to the controller. Assign biCoders to
zone numbers and other devices to their ID numbers.
STEP 3 – Set the Date and Time on the Controller
Press the System Setup button. Highlight the Time &
Date Setup option, and then press OK.
Change all the fields to reflect the current time and
date.
Note: If the controller is connected to BaseManager,
the time will be automatically set by the server.
STEP 4 – Set Zone Runtimes
Press the Program Setup button. Highlight the Zone Runtimes option, and then press OK.
Verify that the correct program number displays in
the upper-left corner. Press PRG to change if
necessary.
Press the  or  button to move to the zone that
you want to set the runtime for. Press the  or 
button to move to the digits that you want to
change. Press the + or – button to change the time.
Page 4