Sony KV-SW14M50 Service Manual page 63

x
Securing the TV
B
KV-SW21M53/SW21M50 only
To prevent the TV from falling, use the supplied screws, clamps and band to
secure the TV. Use only the supplied screws. Use of other screws may damage
the TV.
screws
Screw the band to the TV stand and
to the provided hole at the rear of
your TV.
x Getting Started
Insert the batteries (supplied) into the remote.
Note
• Do not use old or different types of batteries together.
Connect the antenna cable (not supplied) to 8
(antenna input) at the rear of the TV.
Tip
• You can also connect your TV to other optional components (see page 9).
Plug in the power cord, then press ! on the TV to turn it on.
Note
• The 1 (standby) indicator flashes green for a few seconds when
Set up the TV by following the instructions of the "Initial
Setup" menu (see page 5).
Confirm End
Select
4
20 mm
3.8 mm
clamps
or
Step 1
Step 2
Step 3
turning on the TV. This does not indicate a malfunction.
Step 4
Sony KV-SW21M53 Group O3 (
band
(1) Put a cord or chain through the
clamps.
(2) Screw one clamp to a wall or pillar
and the other clamp to the provided
hole at the rear of your TV.
GB, ,
CT MY)_2-636-174-12 (1)