Setting the Test Tone
Use the Test Tone feature to check the speaker connections.
In Stop or no
Press Cursor
1
3
to move to 'TEST
disc mode,
TONE' and then press
press MENU
ENTER button.
button.
•
The test tone will be sent to L ➝ C ➝
R ➝ RS ➝ LS ➝ SW in order.
If the ENTER button is pressed again
at this time, the test tone will stop.
Press Cursor
2
button to move to
'Audio' and then
press ENTER button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
57
press TEST TONE button again.
button
L: Front Speaker (L)
C: Center Speaker
SW: Subwoofer
R: Front Speaker (R)
LS: Rear Speaker (L)
RS: Rear Speaker (R)
Multi-Channel Pro Logic Mode
Start
Setting the DRC
(Dynamic Range Compression)
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
1
In Stop or no disc mode,
press MENU button.
3
Press Cursor
button to
move to 'DRC' and then
press ENTER button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
ENG
2
Press Cursor
button to
move to 'Audio' and then
press ENTER button.
4
Press Cursor
,
to
adjust the 'DRC'.
•
When the Cursor
button is pressed, the effect is greater,
and when the Cursor
button is pressed, the effect is
smaller.
58