Advertisement
Replace Tail Pipe Assembly (60605)
1. Begin with R/S Muffler Assembly. Loosen clamp on right-side clamp and
remove old R/S Tail Pipe Assembly from muffler assembly.
2. Remove the electronic actuator on vehicle right-side rear muffler assembly.
(See Fig. A)
3. Transfer (removed) factory electronic actuator to new R/S Tailpipe As-
sembly using factory hardware. Verify alignment of components and tight-
en bolts 8 ft. lbs.
4. Place a clamp on the expanded edge of the R/S Tailpipe Assembly and
place over the exposed muffler tube. (See Figs. B & C) DO NOT TIGHT-
EN THE CLAMP BOLT.
5. Repeat STEPS 1-4 to replace the L/S Tailpipe Assembly to L/S Muffler.
WARNING: Use extreme caution during installation. Torque all fasteners according to manufactur-
er's torque values and tightening sequence. DO NOT use air impact tools to tighten fasteners on
Borla Performance Exhaust Systems. Use of such tools may result in bent flanges or gasket contact
areas leading to exhaust leaks.
NOTE: When you first start your vehicle after the installation of your new Borla Performance
Exhaust System, there may be some smoke and fumes coming from the system. This is a protective
oil based coating used in the manufacturing of mandrel bent performance exhaust tubing. This is
not a problem and will disappear within a very short period of time after the exhaust has reached
normal operating temperatures.
INSTALLATION GUIDE
Chevrolet Camaro (Gen6)
DOCUMENT PART NUMBER
A-35867 Rev. E
BORLA PERFORMANCE INDUSTRIES
500 Borla Drive
Johnson City TN, 37604-7523
805-986-8600
A
Right Side
B
Right Side
C
Right Side
PAGE
4 of 5
Advertisement
