Advertisement
5
1.3.4 Focus and tracking AGC
This adjustment is to automatically adjust the focus and tracking servo loop gains.
Adjusting procedure
1) Introduce disturbance to the servo loop.
2) The error signals (FE and TE) when disturbance is introduced are extracted through the band pass filter, to obtain the
G1 and G2 signals.
3) The CPU of the LSI reads the G1 and G2 signals through the CD of the LSI.
4) The CPU of the LSI calculates the necessary correction and performs the loop gain adjustment inside the CD of the
LSI.
For increased adjustment accuracy, the same adjustment process is repeated a few times.
1.3.5 RF level auto-adjustment (RFAGC)
This adjustment is to adjust the dispersion of the RF level (RFO), which may be caused by mechanism or disc-related
factors, to a steady value for reliable signal transmission. The adjustment is performed by changing the amp gain between
RFO and RFAGC.
Adjusting procedure
1) The CPU of the LSI issues a command and reads out the output from the RF level detection circuit inside the CD of the
LSI.
2) From the read values, the CPU of the LSI calculates the amp gain to change the RFO level to the target.
3) The CPU of the LSI sends a command to the CD of the LSI to adjust the amp gain to the level calculated in 2).
This adjustment is performed
1) when only the focus close operation is completed during the setup mode, and
2) immediately before the setup is completed (or when the play mode is about to start).
1.3.6 Adjustment of gains in preamplifier stage
In this adjustment, when reflected beams from the disc surface are extremely weak, such as when the lens is dirty, or a
CD-RW is played, gains in the whole RFAMP block (FE, TE, and RF amplifiers) are increased by + 6 dB or + 12 dB,
depending on the situation.
Adjusting procedure
When the system determines that the reflected beams from the disc surface are extremely weak during the setup mode,
the whole RFAMP gains will be increased by + 6 dB or + 12 dB.
1.3.7 Initial values in adjustment
All automatic adjustments immediately after inserting a disc are performed based on the initial values. Automatic
adjustments by source change or ACC ON are basically performed using the previous adjustment values as the initial
values.
5
6
CX-3195
6
7
7
8
A
B
C
D
E
F
15
8
Advertisement
