Shooting Guide - Glendinning Cablemaster User's Installation And Operation Manual

O
PERATION OF THE
I
C
TO EXTEND CABLE
1) Flip the power switch to
cord plug.
2) Walk to dock power source and plug power cord into
recepticle.
3) Cablemaster will automatically shut itself OFF when
cable has fully extended. If less cable is more desire-
able, turn switch OFF and place in the
4) Turn power switch OFF when desired cable length is
acheived.
T
J
ROUBLE
COMPLAINT
Non-functional
• Tripped breaker
(either no power or
• Power wire incorrectly connect-
unit has power and
ed to relay assembly
does not respond)
• Defective motor
• Defective relay box
Pays out cable only
• In-Limit switch circuit open
• Power inputs reversed
• Defective relay or diode
• Bad power switch
Retracts cable only
• Out-Limit switch circuit open
• Defective relay
• Bad power switch
Tripped DC breaker
• Main pulley too tight
• Cable jammed and kinking
• Defective motor
C
ABLEMASTER
O I
ABLEMASTER PERATING NSTRUCTIONS FOR
position; grasp the power
OUT
position.
IN
S G
HOOTING
PROBABLE CAUSE
CM-4, CM-7, CM-8
1) Disconnect the power cord plug from the dock power
source.
2) While holding power plug, walk to Cablemaster.
3) Flip the power switch to the
4) Cablemaster will automatically shut itself OFF when
cable has fully retracted.
** Do not move vessel until cable is fully retracted!
UIDE
RECOMMENDED ACTION
• Reset breaker
• Replace relay assembly
• With power switch on and voltage across motor wires
— if no response, replace motor
• Check in-limit switch
• Check polarity on DC input wires
• Replace relay assembly
• Check power switch
• Check out-limit switch
• Replace relay assembly
• Check power switch
• Adjust pulley
• Check for adequate storage space and/or cable for
undue kinking — see Cable Adjustment (pg. ?)
• Disconnect motor wires from relay box. Apply power
directly to motor wires; motor should run one direction or
other — no response from motor; replace motor
:
MODELS
TO RETRACT CABLE
position.
IN
10