Advertisement
Installation Instructions
HFM Hazardous Location Floodlight
Class 1 Div 2
Groups A, B, C, D
The standard fixture comes with a yoke mounting bracket which can easily be mounted to a variety of accessory mounting hardware.
1. Mount floodlight to desired mounting hardware.
2. Loosen the 2 captive screws in front housing and allow fixture to hinge open.
3. Loosen the two screws and remove optical assembly.
4. Secure appropriate conduit fitting (not provided) to fixture hub provided. Make wire connections. For multi-tap ballast, refer to
instructions below.
5. Replace optical assembly with two screws.
6. Lamp fixture per instructions below. Close front housing, and tighten the 2 captive screws.
OPERATING TEMPERATURE:
"T-Code", listed for this luminaire is based on the following
bulb sizes. Use of any other than these may result in a
higher operating temperature.
Lamp Installation: Loosen the 2 closing screws, hinge door assembly forward to access lamp compartment . Verify that the lamp source
and wattage corresponds with the fixture and ballast label. HID -Screw the lamp securely into the socket, back it out one or two turns,
and tighten securely again. This procedure properly seats the lamp in the socket.
Multi-tap Ballast (TB):
The multi-tap ballast will be prewired for 277V at the factory. First determine the correct line voltage. Then
select the corresponding fixture voltage lead, remove the crimped cap and connect to the supply voltage lead. The fixture lead marked
COM should be connected to the neutral supply lead for 120 or 277. For 208 or 240, connect the other incoming hot leg to the fixture lead
marked "COM". Be sure to cap off all unused fixture leads individually.
Troubleshooting: If this fixture fails to operate properly, check to make sure: The proper lamp is installed correctly.
wired correctly.
• The lamp is not faulty.
©2001 Acuity Brands Lighting, Inc.
All Rights Reserved. Rev. 06/10
Delivery: Upon receipt of fixture and accessories (packed separately), thoroughly
inspect for any freight damage. All damage should be reported to the delivery
carrier. Compare the catalog description listed on the packing slip with the
fixture label on the inside of the housing to be sure you have received the
correct merchandise.
The operating temperature
• The fixture is grounded correctly.
Lithonia Lighting Outdoor
One Lithonia Way, Conyers, GA 30012
Phone: 800-279-8041 Fax: 770-918-1209
www.lithonia.com
Lamp Type
Wattage
High Pressure Sodium
100
High Pressure Sodium
150
Metal Halide
150
Metal Halide
175
Close door using the standard closing screws.
• The line voltage at the fixture is correct.
Bulb Size
Base
ED 17
Med
ED 17
Med
ED 17
Med
ED 17
Med
• The fixture is
Part Number: RJ5210151 Rev B
Revision Date: 6/16/10
Advertisement
