Installation; Power Cord; Power Amp - Pioneer DEH-S1100UB Operation Manual

This unit
L
Power cord input
i
Rear output or subwoofer output
I
Antenna input
4 Fuse (10 A)
Power cord
Perform these connections when not connecting
a rear speaker or middle range speaker lead to a
subwoofer.
1 - - - - -@
1---- -131
1 - - - - -@
L....----@
Perform these connections when using a subwoofer
without the optional amplifier.
f - - - -- @
1 - - - -@
1--- - -@
~----@
c!}
Important
In the case of @) above, two 4 0 subwoofers wired
in parallel will represent a 2 0 load.
CD
To power cord input
® Left
\]) Right
@ Front speaker
® Rear speaker
@ White
(J) White/black
@ Gray
® Gray/black
@> Green
® Green/black
@ Violet
JJ. Viqlet/black
. J 4 Black (chassis ground)
Connect to a clean, paint-free metal location.
.JSYellow
Connect to the constant
12
V supply terminal.
)6
Red
Connect to terminal controlled by the ignition
switch (12 V DC).
ll
Blue/white
Connect to the system control terminal of
the power amp or auto-antenna relay control
terminal (max. 300 mA 12 V DC).
JB Subwoofer
(4
0)
19
When using a subwoofer of
2 0 ,
be sure to
connect the subwoofer to the violet and violet/
black leads of this unit. Do not connect anything
to the green and green/ black leads.
@ Not used.
@.
Subwoofer (4 0) x 2
Power amp (sold
separately)
Perform these connections when using the optional
amplifier.
CD
System remote control
Connect to blue/white cable.
1' 2 '
Power amp (sold separately)
G) Connect with RCA cables (sold separately)
I!; To rear output or subwoofer output
® Rear speaker or subwoofer
!>- Important
• Check all connections and systems before final
installation.
• Do not use unauthorized parts as this may cause
malfunctions.
· Consult your dealer if installation requires drilling
of holes or other modifications to the vehicle.
• Do not install this unit where:
-it may interfere with operation of the vehicle.
- it may cause injury to a passenger as a result of
a sudden stop.
• Install this unit away from hot places such as near
the heater outlet.
• Optimum performance is
obtained when the unit is
installed at an angle of less
than
60°.
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
Leave ample
space