Table of Contents
Advertisement
GEttInG StArtEd
BATTERY INSTALLATION
NOTE: For best performance, remove all factory-installed batteries
from the VTech
batteries.
1. Make sure the unit is OFF.
2. Locate the battery cover on the bottom of
the ELECTRONIC TRAY and open it with a
screwdriver.
3. Install 2 new AA size batteries following
the diagram inside the battery box. (New
alkaline batteries are recommended for
maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
My 1st ToolBox and use new alkaline
®
4
Advertisement
Table of Contents
