Central Machinery 61790 Owner's Manual & Safety Instructions page 9

troubleshooting
problem
Tool will not start. 1. Cord not connected.
2. No power at outlet.
3. Internal damage or wear.
Tool operates Extension cord too long or
slowly. wire size too small.
Overheating. 1. Blocked motor housing vents.
2. Motor being strained by long or
small diameter extension cord.
3. Motor being strained by
over-full Collection Bag.
Suction loss. Collection Bag / Filter Bag
is loose or leaking.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Item 61790
possible causes
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker.
If breaker is tripped, make sure circuit is right
capacity for tool and circuit has no other loads.
3. Have technician service tool.
Eliminate use of extension cord. If an extension cord
is needed, use one with the proper diameter for its
length and load. See table a on page 7.
1. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
2. Eliminate use of extension cord.
If an extension cord is needed, use one with
the proper diameter for its length and load.
See table a on page 7.
3. Empty Collection Bag. Do not
allow to fill past 3/4 full.
Tighten Clamps on Bags.
Page 9