Getting Ready To Make A Call - Sanyo A1303SA Operating Instructions Manual

Getting Ready to Make a Call

1
Charging with the Sanyo AC Adapter 02
1. Insert the connector of the Sanyo AC adapter 02 firmly into the desktop
charging holder.
2. Connect the plug of the Sanyo AC adapter 02 into an AC wall outlet.
3. Put the telephone (A1303SA) with battery pack attached into the desktop
charging holder, paying attention to the installing direction.
Install the body securely onto the charging holder and make sure that the
light (of incoming call / charging) lights up in red.
While charging
Fully charged
4. When fully charged, remove the phone (A1303SA) from the desktop charging
holder, then disconnect the plug from the AC wall outlet.
au telephone
(with battery
pack attached)
③
You can charge the battery with turning the power ON, but it will take longer.
●
If the battery has not been used for a long period or not charged for some time after sounding the alert
●
tone, it may not start charging. When the battery pack is still usable, the reception lamp lights up in a
couple of minutes and the "
When you charge the battery in weak signal areas, it might take time for the light (of incoming /
●
charging) to light up after you set the phone into the desktop charging holder.
When installing the phone into the desktop charging holder, do not move the phone around while it is
●
in the holder. Failure to do so will cause a damage of the phone or poor contact with the holder.
After charging, pull out the connector by pushing release buttons on the both sides.
●
Using the desktop holder, the phone transmits the data even while being charged.
●
7
Light
lights up in red
lights up in green
Light
(lights up in red)
④
①
Desktop charging holder
" also lights up to start charging.
Display / sub-display
" " or "
Phone power is ON → The "
Phone power is OFF → Disappears
Sanyo AC adapter 02
" appears
" appears
Charging time:
approximately 100
minutes.
②
AC wall outlet