Changing Wiper Blades; Tire Information - Honda INSIGHT Owner's Manual

MAINTENANCE

Changing Wiper Blades

If the wiper blades leave streaks across the windshield, try cleaning them first
with a paper towel or soft cloth and wiper fluid. If the wiper blade rubber has
deteriorated, you should change the wiper blades.
1. Set the power mode to VEHICLE OFF.
2. While holding the wiper switch in the MIST position, set the power mode to
ON, then to VEHICLE OFF. Both wiper arms are now set to the maintenance
position.
3. Lift the driver side wiper arm first, then the passenger side.
4. Press and hold the tab, then slide the
holder off the wiper arm.
5. Pull the wiper blade to the opposite
direction to slide it out from its holder.
6. Insert the flat side of the new wiper
blade onto the bottom part of the holder.
Insert the blade all the way.
7. Install the end of the wiper blade into
the end cap.
8. Slide the wiper holder onto the wiper
arm, then push down the lock tab.
9. Lower the passenger side wiper arm
first, then the driver side.
10. Set the power mode to ON and hold the wiper switch in the MIST positions
until both wiper arms return to the standard position.
126 |
Avoid dropping the wiper arm, as it may damage the windshield.

Tire Information

To safely operate your vehicle, your tires must be of the proper type and size, in
good condition with adequate tread, and properly inflated.
Inflation Guidelines
n
• Properly inflated tires provide the best combination of handling, tread life,
and comfort. Refer to the driver's doorjamb label or the specifications see
SPECIFICATIONS for the specified pressure.
• Underinflated tires wear unevenly, adversely affect handling and fuel
economy, and are more likely to fail from overheating.
• Overinflated tires make your vehicle ride harshly, are more prone to road
hazards, and wear unevenly.
• Every day before you drive, look at each of the tires. If one looks lower
than the others, check the pressure with a tire gauge.
• Measure the air pressure when tires are cold. This means the vehicle has
been parked for at least 3 hours, or driven less than 1 mile (1.6 km). If
necessary, add or release air until the specified pressure is reached. If
checked when hot, tire pressure can be as much as 4-6 psi (30-40 kPa,
2
0.3-0.4 kgf/cm ) higher than checked when cold.
• At least once a month or before long trips, use a gauge to measure the
pressure in all tires, including the spare
can lose 1-2 psi (10-20 kPa, 0.1-0.2 kgf/cm
Inspection Guidelines
n
Every time you inflate the tires, check for the following:
• Any damage to tires, including bumps, bulges, cuts, splits, or cracks in
the side or tread. Remove any foreign objects and inspect for air leaks.
Replace tires if you see fabric or cord.
• Uneven or excessive tread wear. Have a dealer check the wheel
alignment.
• Cracks or other damage around the valve stems.
MAINTENANCE
*1
. Even tires in good condition
2
) per month.
*1 - If equipped
| 127