External Accessory Control Operation - Alpine iLX-F309 Owner's Manual

External Accessory Control Operation

You can set the headlights to ON/OFF or adjust the air suspension from
this unit by connecting the optional External Accessory Control
module.
• In order to keep external accessory control outputs on during the
ignition cycle, please change "Accessory During Crank" to "On".
Otherwise all switches will be turned off.
[Setup] [System] [Factory System Setup]
[Maestro Features] [Maestro Module]
Crank] "On"
The following explains how to edit the control switches, because the
functions that can be controlled differ depending on the type of vehicle.
You cannot edit the External Accessory screen while
driving.
Your vehicle must be parked with the ignition key in the ACC or ON
position. For details, see "To display the Setup Menu screen" in
"Setup Operation" (page 26).
1
Touch [Ext Acc Ctrl] in the Menu screen to activate
External Accessory screen.
The External Accessory screen is displayed.
2
Touch [ ] (Edit).
The Edit Control Switches screen is displayed.
3
Edit each switch.
When changing an icon:
Touch the icon, and select your desired icon from the Icon Type
list. After selecting the icon, set the Output Type (Timing) for
each function.
* The Output Type (Timing) sets the operating time for that function
when you touch the icon on the External Accessory screen.
Pulse: The operating time when you touch the icon. (Select
from 11 steps, ranging 0.5 sec. to 10 sec.)
Latch: Switch On/Off by touching the icon.
Momentary: Operating time lasts from when an icon is touched to
when it is released.
80
-EN
[Maestro Module]
[Accessory During
4
5
• If you touch [
screen returns to the previous Edit screen.
When changing the name:
Touch the icon name, then input characters into Edit Name
(Keypad). You can also select a basic name from the [Template]
of the Keypad. For details on how to input characters using the
keypad, see "How to Input Characters and Numbers (Keypad)"
(page 20). (When a basic name is selected from the Template,
the icon will be changed according to the basic name.)
When changing the layout of the switches:
Drag and drop an icon to the desired location.
To revert to a default icon:
Touch the check box " " of the icon that you want to revert to
default, and then touch [ ] (Reset). If you touch [
All), all icons revert to default icons.
After editing is complete, touch [ ] (Back).
After the caption for the confirmation is displayed, touch
[OK].
] (Cancel) while editing, the edits are reset and the
] (Reset