Table of Contents
Advertisement
14. Switch out of memory LOAD and press [4]. The message should now read "NR 162 DE K1XX
K". You have just edited your old message!
15. Now press [4] again and play back the message until NR 163 DE and press the dot key paddle
to hold the message ahead of K1XX. Switch the memory switch to LOAD and press [*][5] to ed-
it. With the paddle send "K1XX" and (without pressing [#]) switch the memory switch out of
LOAD mode.
16. Press [4] and and the message should now read "NR 164 DE K1XX K1XX". You have just
edited a message by inserting a word in the middle!
17. Now switch the memory switch to LOAD and press [4] and send "TEST" with your paddle. With-
out pressing [1] return the memory switch from the LOAD mode and press [4]. The message
should now read "TEST NR 165 DE K1XX K1XX K". You have now edited the message by add-
ing on to the front of the message.
Automatic Message Repeat
1. Switch the memory switch to LOAD and press [1]. Send "CQ CQ DE K1XX K1XX K", press [#]
and switch out of LOAD.
2. Turn the repeat switch/pot clockwise until the repeat LED lights. Turn the pot all the way clock-
wise until the message you loaded into location 1 is automatically activated. A delay time of up
approximately two minutes is possible with the CK-2.
3. In the middle of the message playback in the repeat mode, try tapping the paddle to interrupt
the message. Note that no additional character is transmitted until after you let up on the pad-
dle /the first time) and then commence sending. When no characters have been manually sent
for a period of time equal to the delay setting, the CK-2 will automatically start sending mes-
sage 1 again.
5
Advertisement
Table of Contents
