Table of Contents
Advertisement
Serial Numbers in Memory Send
3.
The serial number will automatically incremented when a message containing a serial number
is completed. If the message is interrupted, the serial number will not be incremented.
A new starting serial number may be loaded, in memory send mode by pressing
[*][*][0][N][N][N][N], where N N N N is the new, one to four digit, serial number.
The previous serial number may be repeated by pressing, in memory send mode, [*][0] before
starting the message. The same serial number will continue to be sent as long as the message
number is preceeded by [*][0].
Editing Messages in Memory
Edit Capabilities
1.
Messages in memory may have additions placed anywhere in the message and deletions from
any point in the message to the end of the message.
Insertion
2.
To insert additional text in an existing message, play the message in memory send mode and
halt the message at the desired point with either paddle or the pound [#] key. Switch to memory
load, press [*][5] and key the desired addition. Switch back to memory send without pressing
[#].
If the insertion is at the very beginning of a message, switch to memory load, press the digit of
the message location and key in the desired addition, then switch back to memory send with-
out pressing [#].
Deletion
3.
During message loading, operation of the pound [#] key signals the end of message and erase
the previous message from that point to the end of that message location. This may be used for
partial message deletion as well as complete message erasure.
For a partial deletion, in memory send mode, play the message to desired point and halt it with
either paddle or pound [#] key. Switch to memory load, and press [*][5]. At this point additional
message text may be entered if desired. Press the pound [#] key. The message will be termi-
nated at this point and the remaining text of the message will be deleted.
Automatic Message Repeat
Message Location
1.
The CK-2 will continuously repeat any message stored in memory location 1.
Delay Interval
2.
The delay interval (time from completion to message to next beginning) can be set from approx-
imately 2 seconds to 2 minutes with the REPEAT DELAY control knob.
Operation
3.
Rotating the REPEAT DELAY knob clockwise enables the Automatic Message Repeat function.
The message in memory location 1 will start to be sent after a time interval determined by the
position of the knob. Rotating further clockwise decrease the delay.
The message being sent can be interrupted with the paddle or [#] key as before, but with a dif-
ference. If no other action is taken after the interruption, the message will restart at the begin-
ning after the delay period. Anytime during this period, a hand keyed message may be sent.
The stored message will restart when no characters have been manually sent for a period of
time equal to the delay setting.
10
Advertisement
Table of Contents
