Table of Contents
Advertisement
SAFETY INSTRUCTIONS
ANTENNA
Outdoor Antenna Grounding
y
If an outdoor antenna is installed,
follow the precautions below. An
outdoor antenna system should not
be located in the vicinity of overhead
power lines or other electric light or
power circuits, or where it can come
in contact with such power lines or
circuits as death or serious injury can
occur. Be sure the antenna system
is grounded so as to provide some
protection against voltage surges and
built-up static charges. Section 810
of the National Electrical Code (NEC)
in the U.S.A. provides information
with respect to proper grounding of
the mast and supporting structure,
grounding of the lead-in wire to
an antenna discharge unit, size of
grounding conductors, location of
antenna discharge unit, connection
to grounding electrodes and
requirements for the grounding
electrode.
Antenna grounding according to the
National Electrical Code, ANSI/NFPA
70
Ground Clamp
Electric Service
Equipment
Ground Clamp
NEC: National Electrical Code
IC (CANADA)
Industry Canada Statement:
This device complies with RSS-210 of
the Industry Canada Rules. Operation
is subject to the
following two conditions:
1) this device may not cause
interference and
2) this device must accept any
interference, including interference
that may cause undesired operation
of the device.
Avis d'Industrie Canada :
Cet appareil est conforme à la norme
CNR-210 des règlements d'Industrie
Canada. Son fonctionnement
est sujet aux deux conditions
suivantes :
1) Cet appareil ne doit pas provoquer
d'interférences et
2) Cet appareil doit accepter toutes
les interférences, y compris
celles pouvant entraîner son
dysfonctionnement.
IC Radiation Exposure Statement:
This equipment complies with IC
radiation exposure limits set forth for
an uncontrolled environment.
NOTE: THE MANUFACTURER IS NOT
Antenna Lead in Wire
RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY
Antenna Discharge Unit
UNAUTHORIZED MODIFICATIONS
(NEC Section 810-20)
Grounding Conductor
TO THIS EQUIPMENT. SUCH
(NEC Section 810-21)
MODIFICATIONS COULD VOID THE
Power Service
GroundingElectrode
USER'S AUTHORITY TO OPERATE
System (NEC Art 250,
Part H)
THE EQUIPMENT.
Advertisement
Table of Contents
