Samsung SRP-250 Series Operator's Manual page 2

Warning - U.S.
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates uses, and can radiate radio frequency energy and if
not installed and used according to the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his
own expense.
Notice - Canada
This Apparatus complies with class "A" limits for radio interference as specified i n the
Canadian department of communications radio interference regulations.
Get appareil est conforme aux normes class "A" d' i nterference radio tel que specifier par
ministre canadien des communications dans les reglements d' i nterference radio.
Caution
Some semiconductor devices are easily damaged by static electricity. You should turn the
printer "OFF", before you connect or remove the cables on the rear side, in order to guard the
printer against the static electricity. If the printer is damaged by the static electricity, you should
turn the printer "OFF".
INTRODUCTION
The SRP-250 and SRP-250P Roll Printer are designed for use with electronic instruments
such as system ECR, POS, banking equipment, computer peripheral equipment, etc.
The main features of the printer are as follows:
1.
High speed printing : 3.5 lines per seconds.
2.
2 color dot-matrix printer.
3.
RS-232 serial interface (SRP-250). Parallel interface (SRP-250P)
4.
The data buffer allows the unit to receive print data even during printing.
5.
Peripheral units drive circuit enables control of external devices such as
cash drawer.
6.
Characters can be scaled up to 64 times compared to it' s original size.
7.
Bar code printing is possible by using a bar code command.
8.
Different print densities can be selected by DIP switches.
Please be sure to read the instruction in this manual carefully before using your new
SRP-250/SRP-250P.
NOTE : The socket-outlet shall be near the equipment and it
shall be easy accessible.