Admiral RX1000 Quick Start Manual

Admiral RX1000 10-Channel DSMX™
Compatible Receiver
with Diversity Antenna
Identifying the RX1000's Ports
The RX1000 has 12 ports. BIND is for the Binding/Fail-
Safe process; the unlabeled port is for configuring the
receiver for high-speed, digital servos. AUX1-AUX5 are
for surfaces or other controls, such as flaps or gyro
control. The rest are labeled with their intended
channels, but they can be used for other purposes.
Throttle
Aileron
Elevator
Rudder
Gear
Auxiliary 1-5 Auxiliary 1-5

Quick Start Guide

Binding the RX1000

To bind the RX1000 to your transmitter, perform the following steps:
1. Insert the Bind plug onto the BIND port.
2. Connect the receiver to power, such as
3. Turn on your transmitter and put it in Bind
4. When the red Bound light (located on the
5. Remove power from the receiver.
6. Remove the Bind plug from the receiver.
7. Turn off the transmitter.
Test the connection by turning on the
transmitter and then powering the receiver. The
Bound light should illuminate.
Bind
Bind for High- Always perform a range test before flying the
Speed Servos
model. See the instructions for your transmitter for the
details.
connecting an ESC's throttle lead to the
THRO port and a battery to the ESC. The
receiver's Bind Mode light (located on the
bottom) flashes quickly, indicating it is in
Bind mode.
mode. Usually, this involves holding a
switch or button (such as the Trainer switch)
while turning the transmitter on. (See the
instructions for your transmitter for the
details.)
bottom of the receiver on the side opposite
to the ports) illuminates, release the Bind
switch or button on the transmitter. The
RX1000 is bound to the transmitter.
Bind Mode
Bind Plug
Light
Bound Light
Page 1