Table of Contents
Advertisement
1. Carefully inspect the outer packaging for evidence of damage during transporation.
Do not install a damaged cabinet. Report any damage to the carrier and contact service
representative immediately.
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site,
before unpacking. Insert the forklift or pallet jack's forks between the pallet supports
and the bottom of the unit. Do not tilt the UPS cabinet more than 10° from vertical or the
cabinet may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft)
on each side for removing the cabinet from the pallet.
4. Remove the protective covering from the cabinet.
5. Remove the packing material, and dispose them in a responsible manner.
6. Visual inspection: whether there is any transporting damage happened to the UPS,
including the internal and external of the battery. If yes, report to the carrier immediately.
7. Check up the product label and confirm the correctness of the equipment. The
equipment label is fixed behind the door of the equipment .And information such as
UPS model , capacity and main parameters is written in the label.
2.3 Storage
Keep UPS indoor with well air ventilation to avoid the over-wetting or
over-temperature environment.
2.4 Link (Connection)
After the complete position of the equipment, link the power wire referring to the
connection diagram in the Section V and according to the following steps:
Completely cut all input distribution switches and the internal power switches the
UPS. Stick the warning mark in these switches to avoid other people to operate them.
Open the UPS door and take down the under part protection cover, and the copper
bar of the connection power cable can be at your sight.
Connect the protection ground and other necessary earthing cable to the eathing
copper bar of the bottom in the UPS power supply equipment. All UPS cabinets should
be connected with the user's earthing device.
Note: The connection of the ground wire and the midline should comply to the local
and the state's relevant regulation.
3Phase HF UPS 10-120kva USER Manual
Page8
Advertisement
Table of Contents
