Flash Mode - Panasonic DMW-FL200L Operating Instructions Manual

∫
Firing a test flash

Press the [TEST] button while the [CHARGE] lamp is lit to
fire a test flash.

Flash Mode

Choose a flash mode according to
your subject and shooting
conditions.
Set the mode lever to the
appropriate position.
[TTL] (TTL AUTO)
The flash light intensity is controlled automatically
according to the camera's setup. The flash will be adjusted
based on the brightness taken through the camera's lens.
Usually use this mode with a camera with communication
capability.
Rotate the flash exposure
compensation/output control dial to
adjust the flash output.
≥ You can make an adjustment by
selecting a value between j3 EV
and i3 EV.
≥ Select [0] when not making an adjustment.
1 [CHARGE] lamp

2 [TEST] button
[MANUAL]
The flash is fired at the intensity that you set.
Select this mode when using a camera without
communication capability.
Rotate the flash exposure
compensation/output control dial to set
the flash output.
≥ You can set a value between [1/1]
(full flash) and [1/64].
[SLAVE] (SL MANUAL)
The flash can be fired remotely in sync with any flash fired
by other units.
The flash is fired at the intensity that you set.
Rotate the flash exposure
compensation/output control dial to set
the flash output.
≥ You can set a value between [1/1]
(full flash) and [1/64].
[RC]
Wireless control is available with Panasonic digital
cameras that support wireless mode. (P10)
9
SQT1378