Advertisement
1. Thread 1/2" Pendant Hub onto conduit and pull supply wiring through conduit.
Pendant Mounting:
"version C"
Note: Be sure to use Teflon tape to seal 1/2" NPT threads for Wet Location Environments!
2. Remove PC Lens
(Glass & Guard),
wiring connection as indicated below. Next attach LED Heatsink to Pendant Hub using the two (2) screws provided in
polybag. Insert the screws through the holes on the inside of LED Heatsink and align the screws with the holes on the
Hub and tighten securely
3. Replace PC Lens
(Glass & Guard),
A
Junction Box
Adaptor Plate
LED Heatsink
PC Lens
Junction Box
Cover
Gasket
O-ring
Heatsink
Reflector
Gasket
Globe
Guard
Wiring Connections:
CAUTION: Check that supply voltage is compatible with fixture ballast.
Use approved connectors for all electrical connections.
Connect the black fixture wire to the black supply wire (line).
Connect the white fixture wire to the white supply wire (neutral).
Connect the green fixture wire to the junction box ground wire.
Form #D-1281 LDPI, Inc. 1-800-854-0021
INSTALLATION INSTRUCTIONS
using gasket provided in polybag, thread wiring through the gasket opening and make
onto fixture by threading until tight (care must be given to not cross thread).
Gasket
Gasket
Reflector
Gasket
Web:http://www.ldpi-inc.com Email: sales@ldpi-inc.com
B
Junction Box
Wall Bracket
Quick
Disconnect
LED Heatsink
Reflector
PC Lens
Junction Box
Wall Mount Arm
Disconnector
O-ring
Heatsink
Reflector
Gasket
Globe
Guard
Page2
C
Pendant Hub
Gasket
LED Heatsink
Reflector
PC Lens
Pendant Hub
Gasket
O-ring
Heatsink
Reflector
Gasket
Globe
Guard
Advertisement
