Setting Astronomic On/Off Events - Intermatic ET2825C Installation And Setup Instructions

Setting Astronomic On/Off Events

Access the Astro Events screen to configure Astronomic ON/OFF events for each individual circuit. For each circuit one Astronomic
ON event (at sunset) and/or one Astronomic OFF event (at sunup) can be enabled for selected days of the week. Follow this
procedure to set Astro ON/ OFF Events (if no astronomic events need to be set press MODE to move to the next mode selection).
Press MODE to advance until SET ASTRO
1.
already active). The display also shows the ON@ icon and the LOAD icon above the circuit #1 button.
2. If an event is not set the time display will show - - - -.
3. Press DAY. The screen displays SUNSET and the days of the week.
If the desired days for this event
are
MON-SUN
MON-FRI
SAT-SUN
SET EACH DAY INDIVIDUALLY
On the display, the day of the week
being set is flashing.
4. Press – to eliminate this event or press + to keep this event for the selected day.
5. Press DAY to move to the next day of the week repeat step 4.
6. When all the days are set, press ENTER/NEXT to save.
7. The display changes to SET ASTRO
8. If an event is not set the display will show - - - - .
9. Press DAY. The screen displays SUNUP and the days of the week.
If the desired days for this event are Then
MON-SUN
MON-FRI
SAT-SUN
SET EACH DAY INDIVIDUALLY
On the display, the day of the week
being set is flashing.
10. Press – to eliminate this event or press + to keep this event for the selected day.
11. Press DAY to move to the next day of the week repeat step 10.
12. When all the days are set, press ENTER/NEXT to save.
13. The display shows the SET ASTRO
LOAD icon above the next circuit button.
If
You want to configure an Astro event
for another circuit
All the required Astro events are set
ON/OFF EVENTS
Then
Press ENTER/NEXT to save. Go to step 7.
Press DAY once and then press ENTER/NEXT to save. Go to step 7. .
Press DAY twice and then press ENTER/NEXT to save. Go to step 7.
Press DAY three times and the MON icon should flash.
Go to step 4.
ON/OFF EVENTS SUNUP, the OFF@ icon.
Press ENTER/NEXT to save. Go to step 13.
Press DAY once and then press ENTER/NEXT to save. Go to step 13.
Press DAY twice and then press ENTER/NEXT to save. Go to step 13.
Press DAY three times and the MON icon will flash.
Go to step 10.
ON/OFF EVENTS SUNSET icons. The display also shows the ON@ icon and the
Then
Return to step 2.
Press MODE to save and exit. The procedure is complete.
SUNSET icons appear on the display (if this selection is not