Delay Adjustment; Reference Setting - pro bel V1635V-100 User Manual

·
·
The following table indicates the available Panel Adjustment modes on the two pages.
LED indicator
Parameter
Delay Delay
Ref. Reference
SPS Sample rate
A/B Swap A/B Swap
3.2.2
A fixed delay may be applied to all four analog channels as a group and the present setting
may be seen on the character display as a number when Page 0 Panel Adjustment mode
has been entered and Delay selected as a parameter.
·
·
·
Note: changing the adjustable delay will cause a temporary disruption of audio for a
time not less than the difference between old and new delay settings.
3.2.3
The reference source may be selected and the present setting may be seen on the Ref LEDs
when Page 0 Panel Adjustment mode has been entered and Ref. selected as a parameter.
The selectable options will depend on the V1635V variant as follows:
·
·
12
Vistek V1635V-100 24-bit AES Audio
Once a parameter has been adjusted to the desired value, the Panel Adjustment
mode is exited by pressing the SELECT button until all four of the LEDs above
the SELECT button are off.
The V1635 has non volatile memory storage that automatically saves the values
of all the operating parameters set in
the / switch is switched from
REM LOCAL
mode will be restored. Parameter adjustments take effect immediately but
LOCAL
are only saved to non-volatile memory on the V1635 when the adjustment mode
is exited.
Page 0
Adjust range Parameter
0ms to 2500ms Test Tone
Free, AES, Video Fine Delay
32, 44.1, 48kHz -
Normal/Swapped -

Delay Adjustment

By Panel Selection the delay value may be adjusted from 0ms to 1.25 seconds.
Adjustment is in 1ms steps from 0 to 1250ms. From 0 to 999ms, the delay value
is displayed in ms and from 1.0s upwards it is displayed in seconds to 10ms
resolution, i.e. 1.xx. A decimal point after the least significant digit indicates a
value of delay between the 10ms display values.
The DART interface can control the delay in 1ms steps across the range.
The minimum throughput delay of the V1635 is less than 2ms.

Reference Setting

On cards with analog outputs, only Free Run reference may be selected (all Ref
LEDs off).
On cards with digital outputs and analog inputs, the reference may be set to Free
Run, AES or Video which correspond to Ref LEDs none, AES and Video being lit
respectively.
Variable Delay Module
mode so that on power-up or when
LOCAL
to , the last settings made in
REM LOCAL
Page 1
Adjust range Parameter
A,B Off/A,B on Input Gain A1
{0...47} samples Input Gain A2
Input Gain B1
Input Gain B2
Page 2
Adjust range
{-16dB...+15dB}
{-16dB...+15dB}
{-16dB...+15dB}
{-16dB...+15dB}
HU-V1635V-100