Internal Hardware; Main Board - pro bel VISTEK V6333E/D User Manual

VISTEK V6333E/D & V6333Q/D
hd/sd sdi digital audio multiplexer
2.6

Internal Hardware

2.6.1

Main Board

The purposes of the links and switches is shown in the following table.
ITEM
SW1 RESET
JP1 Debug/Normal Link
TP10 +1.5V
TP17 +3.3V
JP4 +15V Plug
H8 Debug and
JP2
Programming Port
TP2 +1.8V 1
TP23 +1.8V 2
M1 Flash Card
PL1 JTAG Connector
JP3 JTAG enable
FS1 Fuse
HU-V6333E/D&Q/D
Main board with no sub-module
SW1
JP2
JP1
TP10
TP17
JP4
Main board with V6333 sub-module
SW1
JP2
JP1
V6333 Sub-Module
TP10
TP17
JP4
Title Comments
Used to reset the internal microcontroller.
Should be left with no link, for development only.
1V5 Test Point
3V3 Test Point
+15V Alternative supply plug.
For downloading the H8's Bootloader program, and also used as a serial port
for development.
1V8 Test Point from Reg U301
1V8 Test Point from Reg U309
Stores H8 Application code and Firmware for the FPGA. Also used to store
application specific data.
For development and test use only
Link 2-3 for operational use.
The main 2Amp fuse on the frame supply.
Flash Card
M1
TP2
TP23
PL1
JP3
M1 Flash Card
TP23
FS 1
PL1
JP3
TP27
TP25
7