Table of Contents
Advertisement
▲
▼
Beside the
and
buttons are three LEDs marked +,CAL and –. In general the CAL LED is used to
show that a variable is set to its normalised value and if not then the others show in which direction it has
been changed or that it is no longer on its CAL value. The toggle switch Rem/Local selects the source of
control for the module. Remote control is discussed next.
3.2
Remote Control
The V6333 can be controlled from either the front panel, shown above or through the DART remote control
network. If DART is used then any DART controller, with knowledge of the V6333 can be used. Vistek can
provide either the V1605 1U control panel, V1602 2U control panel, or ViewNet, which is a PC based
universal control system. Any DART controller can be used, provided it has 'knowledge' on the V6333.
The control source, Local or Remote, is selected by the toggle switch on the front panel. The REM LED
does not indicate the selection of remote control, but 'blips' to show access by the Rack Controller, if fitted.
Only the position of the toggle switch indicates that remote control has been selected.
The status LEDs on the front panel are active for Local or Remote control so always show the operating
condition.
3.3
Menu System
The menus used for local control and status of the module is a hierarchical menu system with five levels as
follows:
Sleep
Display is blank (except for Banner warnings).
Top Level
e.g. V6333Q/D
Main Menu
The Main menu items, such as VIDEO, ENG'ING etc. These items are all in Upper Case.
Sub Menu
Menu items under each main heading, such as Video or Grp1.1 under the MAIN menu.
These items are all in Sentence Case (generally lower case but with upper case first letters).
Parameter
The lowest level under the Sub Menu, and used to actually adjust a parameter. The display
will depend on the actual parameter and may be a value such as ON or OFF for a switch
variable. There is usually a title to describe the variable and a small icon in the left hand
character position, but 8 characters cannot provide for a detailed description.
To move down a level just press the Select button briefly; then press either the Select button again to go
down another level or the
To move up a level press and hold the Select button for about half a second which will move up one level.
If you continue to hold the Select button then it will move up a level every half a second until it reaches the
Sleep level (one above the Top Level).
The menus are described in the next section.
10
VISTEK V6333E/D & V6333Q/D
hd/sd sdi digital audio multiplexer
▲
▼
and
buttons to move around the options within a level.
Issue 5
Advertisement
Table of Contents
