Epc Gen2 Tag Lock - Marktrace MR6221 User Manual

◢MR62XX Serial UHF reader user manual（Ver 1.0）◣
27
with the EPC Gen2 Protocol, RESERVE Membank's data is invalid for the tag
filter rule setting. Please 1) select the EPC tag Membank, 2) the word addr. 3)
Word Length, 4) Input the value, then Click 'Config' ICON for the Tag filter rule
setting.
1、 Only on Favor quantity working mode, the Tag filter setting is valid, on Favor
speed working mode, tag filter setting is invalid.
2、Match setting, reader reads and displays only the condition matched tag.
3、Mismatch setting, Reader doesn't read and display the condition matched
tag.
4、Empty the input value for cancel the Tag filter rule.
5、If setting EPC Membank as the Tag filter rule, the valid Word Addr is 2.
6、After set the EPC tag filter rule, this rule is valid for all EPC tag detect.
7、After set the EPC tag filter rule, this rule is valid for all the time unless the
reader is power off or reset.

6.1.4 EPC Gen2 Tag Lock

1、On Gen2 EPC Single Tag interface's Gen2 Secured Lock menu for the EPC
Gen2 Tag Lock setting. With Access Password, it can lock Reserve Membank,
EPC Membank, and USER Membank in different lock level. Take below image
for the reference.
Address：
Floor5/7, Block D,Changyuan New Material Port, No 2 Central 1st Hi-tech Av., Nanshan Shenzhen, P.
R.C.
Post：518057
Phone：0755-2654 6392 FAX：0755-2655 3743
E-mail：technical@marktrace.com Website：www.marktrace.com