Uplift Desk LTG001 Instructions

Package Contents

© UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
Lamp

Step 1

To attach the Clamp to the desk, loosen the knob under the Clamp and slide onto
your desk. Tighten the knob until the Clamp is securely fastened to the edge of
your desk. Clamp will fit worksurfaces up to 2.25'' thick

Step 2

Install the Lamp to the Clamp base by sliding the bottom peg of the Lamp
into the hole on the Clamp.

Step 3

Tighten the set screw in the Clamp so the Lamp is secure
and won't come unattached.

Step 4

Plug the end of the Lamp's cord into the Power adapter, and plug the Power
adapter into a wall outlet.
To power on the light, flip the switch on the power cord, and tap the button
on the top of the Lamp's head to turn it on. Tapping this button again will turn
the lamp off.
A warning before use
When the light is lowered down, the space between the arm's first segment
and the stabilizing metal bar can tighten and become a pinch point. To avoid
injury, do not put your fingers or any part of your body in this area.
®
E7 LED Desk Lamp
LTG001
Clamp
Note:
If you purchased the Desk Base (LTG002) or
Floor Base (LTG003), they will have similar holes
and set screws for their assemblies.
Power adapter
Desk Base
Floor Base
LTG001/R01