Advertisement
Quick Links
IMPORTANT
Read and understand all instructions before installing.
NOTE: If your shade does not have a fascia, you may
skip Steps 1,2, 3, and in step 10, install the shade
without adding a fascia.
Step 1 Remove the End Caps.
End caps are
held on by magnets.
Step 3 Remove the Fascia Clips.
1
Push the snap feature
at the bottom of the
Fascia Clip towards the
center of the shade.
2
Rotate the bottom of
the clip toward you.
Fascia
Clip
QBASIC PLUS
MOTOR CONVERSION KIT
INSTALLATION INSTRUCTIONS
Step 2 Remove the Fascia.
Pull down gently
and rotate bottom of
Fascia towards you.
Step 4 Remove the Shade.
Lift up and then out
the end of the shade
opposite the Chain.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for QMotion QBASIC PLUS
Summary of Contents for QMotion QBASIC PLUS
-
Page 1: Installation Instructions
QBASIC PLUS IMPORTANT Read and understand all instructions before installing. MOTOR CONVERSION KIT INSTALLATION INSTRUCTIONS NOTE: If your shade does not have a fascia, you may skip Steps 1,2, 3, and in step 10, install the shade without adding a fascia. - Page 2 Step 10 Reinstall the Roller Shade, Fascia Clips, Fascia, and End Caps in this order. Attach bracket using three screws just removed. For more information visit us at qmotionshades.com or call 877.849.6070 © 2018 QMotion. QMotion is a trademark. All rights reserved. Pub #9000278r1 04/2018...
Need help?
Do you have a question about the QBASIC PLUS and is the answer not in the manual?
Questions and answers