Caution FCC and IC statement for users (USA and Canada IMPORTANT SAFETY INSTRUCTIONS only) This device complies with part 15 of the FCC Rules. Operation For all products: is subject to the following two conditions: (1) This device may 1. Read these instructions. not cause harmful interference, and (2) this device must accept 2.
The directive sets out rules for it for future use. Should the unit require maintenance or repair, please contact your local JBL service. Refer servicing to qualified collection, treatment, recycling and disposal of batteries, and aims to prohibit certain hazardous substances and to improve personnel only.
HARMAN International hereby declares that this equipment is in compliance with EMC 2014/30/EU Directive, LVD 2014/35/EU Directive. The declaration of conformity may be consulted in the support section of our Web Site, accessible from www.jbl.com. For All Products with Wireless Operation HARMAN International hereby declares that this equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
1. INTRODUCTION 2. WHAT’S IN THE BOX Congratulations on your purchase! This manual includes information about “PARTYBOX 200” and “PARTYBOX 300” speakers. We encourage you to take a few minutes to read this manual, which describes the product and includes step-by-step instructions to help you to set up and get started.
Connected Not connected White (Constant) Red (Fast flash) Low battery (for PartyBox White (Slow flash) Charging PartyBox 200 300 only) White (Constant) Charged 3.2 Back Panel 1) AUX • Connect to an external audio device through a 3.5mm audio cable (not supplied).
4. PLACEMENT 5. POWER ON Notes: Cautions: – For best quality sound, ensure the two tweeters are placed on the – Use only provided power cord. upper side of the speaker box. – For PartyBox 300, either AC/DC POWER or built-in battery can be –...
1. Press to enter Bluetooth pairing mode. – Built-in battery charging works on AC power only. 2. Choose “PartyBox 200” or “PartyBox 300” to connect. 6.1 Charge your Speaker Use the AC power to charge your PartyBox 300. Bluetooth Bluetooth 10m (30”)
Audio formats Note: To exit AUX mod, choose Bluetooth or USB as a source first. Extension Codec Sample rate Bitrate WAVE 44.1Khz ~192Khz <5Mbps 7.4 INPUT Connection LPCM 44.1Khz ~192Khz <5Mbps Note: To play music on your analog device through this speaker, IMA_ 44.1Khz ~192Khz <5Mbps...
To adjust the volume of the audio source, press • To adjust the volume of the microphone or guitar, rotate the MIC/GUITAR volume knob. PartyBox 200 Caution: When not using the microphone or guitar, decrease the MIC/GUITAR volume to minimum and remove them from the jack.
8. CARRYING YOUR PARTYBOX 9. SETTINGS Cautions: 9.1 TWS Mode – Before carrying the speaker, make sure that all the cords are The two PartyBox speakers can connect to each other in TWS disconnected. mode. – To avoid personal injury and/or property damage, hold the product firmly while carrying.
10. SPECIFICATIONS 11. TROUBLESHOOTINGS Product name PartyBox 300 PartyBox 200 Caution: Never try to repair the product by yourself. If you have any problems while using this product, check the following points AC power input 100-240V ~ 50/60Hz before you request service.
12. COMPLIANCE 13. TRADEMARK The product is in compliance with the European Union energy legislation. Bluetooth connection mode The product is intended to be used for streaming music via Bluetooth connection. A consumer can stream Bluetooth Este equipamento não tem direito à proteção contra interferência audio to the speaker.